Elite Screens 135170, 71120 User Manual

User Guide

Manual Series

Manual Pull-down screen with a dual case design for wall or ceiling installation

Pre-Installation

1. Carefully unpack the screen.

2. Always handle the screen in a leveled position on a clean surface.

3. In order to protect the screen from exposure to stains, keep the screen out of contact with foreign
objects such as dust, saw dust, and/or liquids.

Note: Regardless of the mounting method, the screen should be securely supported so that

when retracted, deployed, or even abusive pulling on the screen, the case will not become loose
or fall. The installer must insure that the fasteners used are of adequate strength and suitable for
the installation location.

v.1 2

www.elitescreens.com

[e-mail]

Installation

Flush Mount to the Wall

1. Mark the location of where the screen is to be installed and drill your holes.

2. Insert the proper screw and leave about 1/8” of an inch from the wall to mount the screen.

3. Mount your screen from the keyhole located on back of the screen’s left and right end cap.

Back of end cap

Front view

(

Hardware not included

)

Side view

Suspended Ceiling using Chains

You can also hang the screen on a ceiling by using a chain (not included) and hang it by the two loops
(models 71‐120) located on each end of the case or by the ears of the end caps (models 135‐170).

71"-120" 135"-170"

(

Hardware not included

Loops

)

Hole

- 2 -www.elitescreens.com [e-mail]

Screen Operation & Maintenance

Note: Always pull the screen down or retract in a 90‐degree vertical angle. To avoid damaging the

viewing surface, do not allow the viewing material to touch the screen case when deploying or
retracting the unit.

1. Pull the screen down from the lanyard or from the handle only in a 90‐degree angle. Do not attempt to
pull the screen down by the surface, as it will damage the screen and void the warranty.

2. To retract the screen back into its case, simply pull the screen down more than 2 inches and let the
screen retract by quickly and gently releasing it up.

Note: The interval auto‐lock mechanism system will cause the screen to stop and lock on the position

at intervals.

Note: Always release the screen at a 90‐degree angle and do not let go until the screen is entirely

inside the case. Keep in mind the screen’s mechanism is new and needs to be deployed/retracted a
few times to loosen up. If the screen feels stuck, carefully, with a little force, yank the screen straight
down to unlock the unit.

Note: Improper pulling on the screen to deploy/retract will damage material and/or the rolling system.

Maintenance

To clean the viewing material, use a soft cloth with mild soap and water. In order to keep the viewing surface
clean, it is recommended to keep the screen retracted into its housing case when not in use.

- 3 -www.elitescreens.com [e-mail]