Elite Screens 010410-JA User Manual
Elite ezFrame Series
Fixed Frame Projection Screen
User’s Guide
Rev. 010410-JA
www.elitescreens.com info@elitescreens.com
1/2Long frame
Push
Parts List
1. Frame Parts x 6 pcs (4 top/bottom frame pcs. + 2 side frame pcs)
2. Tension Rods x 6 pcs (4 top/bottom rods + 2 side rods)
3. Screen Material x 1 pc
4. Center joints x 2 pcs
5. Elbow Joints x 4 pcs
6. Wall brackets x 2 – 3 pcs (depending on model/size)
7. Screws x 16 pcs
8. User Guide x 1 pc
9. Center Support Bar x 1 – 2 pc s (depending on model/size)
10. Support joiner x 2 – 4 pcs (depending on model/size)
11. Fix Plates x 30 – 90 pcs (depending on model/size)
12. Black cloth backing x 1 pc (AcousticPro1080 models only)
Note: Please make sure all parts are included in your package before proceeding to assemble
your Elite Screens fixed frame projection screen.
ASSEMBLING THE FRAME
1. Insert the center joint connector to the horizontal frame piece and then fasten it with 2 screws
2. Insert the other horizontal frame piece to the center joint connector and then fasten it with 2 screws.
(1)
Push
Push
Short frame
Short frame
Push
Push
Joint
Long frame
( fig.1)
Please do not tighten the screws completely, to make sure the frame piece lines up
correctly.
3. Insert both elbow joint connectors into the long horizontal frame (see fig.1)
4.
(2)
Push
Push
( fig.2)
Insert the exposed ends of the joint connectors
into the short (vertical) frame and align the four
corners so that they meet at perfect right angles
Screw
( fig.3)
4. Join all four frame parts together following the steps showed below. (fig.2)
5. After making sure that all four corners join at right angles to form a perfect rectangle, fasten the four
angles together by using the (x8) joint screws included. (see fig.3)
(3)
Loading...