FEDERAL COMMUNICATIONS
COMMISSION INTERFERENCE
STATEMENT
This equipment has been tested and found to
comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment
and receiver.
Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
Any changes or modifications not expressly approved
by the party responsible for
End Product Labeling
This transmitter module is authorized only for use in
device where the antenna may be installed such
that 20cm may be maintained between the antenna
and users. The final end product must be labeled in
a visible area with the following: "Contains FCC ID:
WL6-TC6BC30CA1
Notice:
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Notice:
This Transmitter must not be co located or
operating in conjunction with any other antenna or
transmitter.
This equipment complies with FCC RF radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed
and operated with a minimum distance of 20
centimeters between the radiator and your
2
body.
Information for the OEMs and Integrators
The following statement must be included with all
versions of this document supplied to an
OEM or integrator, but should not be distributed to
the end user.
1) This device is intended for OEM integrators only.
2) Please see the full Grant of Equipment document
for other restrictions.
This radio transmitter FCC ID: WL6-TC6BC30CA1
has been approved by FCC to operate with the
antenna types listed below with the maximum
permissible gain and required antenna impedance
for each antenna type indicated. Antenna types not
included in this list, having a gain greater than the
maximum gain indicated for that type, are strictly
prohibited for use with this device.
3
Connectors and Pads
1
2
3
4
5
4
Audio FPC Connector
Battery Pad
WiFi/BT/GPS Antenna Pad
RF Test Connector
TP Connector
6
7
8
9
10
11
12
13
LCD Connector
Speaker Pad
Mic Pad
T-flash Card Connector
Side Key Connectors
Bear Camera Connector
Front Camera Connector
Micro USB Connector
Main components
A
B
C
D
CPU+PMIC+DDR+EMMC
WiFi/BT
CODEC
GPS
. Antenna Specification
Type
Trade name
Model
PIFA
Innetech
13H130-JX9070
5
gain
2.85 dBi
6
Loading...