Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for
help.
Caution:
Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
1
RF Exposure Information (SAR)
This device meets the government’s requirements for exposure
to radio waves. This device is designed and manufactured not to
exceed the emission limits for exposure to radio frequency (RF)
energy set by the Federal Communications Commission of the
U.S. Government.
The exposure standard employs a unit of measurement known
as the Specific Absorption Rate, or SAR. The SAR limit set by
the FCC is 1.6 W/kg. Tests for SAR are conducted using
standard operating positions accepted by the FCC with the EUT
transmitting at the specified power level in different channels.
The highest SAR value for the device as reported to the FCC is
W/kg when placed next to the body.
0.469
CAUTION
Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to the instructions.
Attention: Teachers, Parents and Adult Supervisors
This product is an educational tool designed for school children,
ages 6 and up. There must be supervision by an adult on school
children under 10 when using this tablet. It is a must to have a
thorough explanation to students on safe and proper handling of
the tablet, power supply, battery pack, and power cord.
2
Be sure to keep the
power cord away from
younger children
Please ensure that students understand the following:
! As with all electrical products, precautions should be
observed during handling and use to prevent electric
shock. The power supply (adapter) should not be handled
by the children.”
! Emphasize to students that this device is an educational
tool and not a toy. The tablet, power supply, battery pack
or power cord should not be dropped, crushed, stepped
on or otherwise abused.
! Ensure students understand the safe and proper
handling of power cord and power supply. Misuse could
result in serious injury.
! The teacher, parent or adult supervisor should
periodically inspect the tablet; power supply and power
cord for damage and replace it, if necessary.
! Students should report any damage or loose parts to their
teacher, parents or adult supervisor, immediately.
! Do not leave the tablet plugged in or “on” when enclosed
in a non-vented container, such as a school backpack, as
overheating may occur.
! It is recommended that students should take a 5-minute
break every 30 minutes of use.
Safety Precautions
The following are lists of precautionary measure the students
must understand before using this tablet inside the classroom or
home environment:
1. Do not place near the fire or other sources of heat.
2. Do not expose to magnetic fields.
3. Do not expose to direct sunlight.
4. Do not expose to rain or moisture.
5. Do not place heavy objects to add heavy pressure
on the tablet.
6. Do not drop the tablet.
Réglementation de la commission fédérale des communic
ations sur les interférences
Cet équipement a été testé et déclaré conforme aux normes
des appareils numériques de Classe B, conformément à
l'article 15 du règlement de la FCC. Ces limites sont conçues
pour offrir une protection raisonnable contre les interférences
néfastes dans une installation résidentielle. Cet appareil
génère, utilise, et peut diffuser de l'énergie radioélectrique et,
s'il n’est pas installé et utilisé conformément aux instructions, il
peut causer des interférences nuisibles aux communications
radio. Cependant, il n'est pas garanti que des interférences
ne se produiront pas dans une installation particulière. Si cet
appareil provoque des parasites dangereux qui affectent la
réception radio ou de télévision, ce que vous pouvez
déterminer en éteignant et en rallumant l'appareil, l'utilisateur
est encouragé à essayer de corriger ces interférences en
employant l'une des méthodes suivantes:
- Réorientez ou déplacez l'antenne de réception.
- Eloignez le matériel du récepteur.
- Branchez le matériel à une prise fonctionnant sur un circuit
différent de celui sur lequel le récepteur est connecté.
- Consulter le revendeur ou un technicien radio ou
télévision expérimenté.
Attention :
Tous changements ou modifications n'ayant pas été
expressément approuvés par l'organisme responsable de la
conformité peuvent enlever tout droit à l'utilisateur de faire
fonctionner ce matériel.
Cet appareil est conforme à la partie 15 des règles de la FCC.
L’utilisation de cet appareil est soumise aux deux conditions
suivantes :