Elitair ZN-36 User Manual

USA

RANGE HOOD - User instructions

F

HOTTE PER CUISINE - Notice d'utilisation

E

CAMPANA EXTRACTORA - Manual de utilización

I

CAPPA ASPIRANTE - istruzioni per l’uso

- 2 -

Fig.1 Fig.2

A

B

20

235

A

C

Fig.3 Fig.4

Fig.5 Fig.6

- 3 -

A

AB

C

B

Fig.7

A

C

B

G

E

D

A

E

D

F

- 4 -

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS

FOR RESIDENTIAL USE ONLY

READ AND SAVE THESE INSTRUCTIONS

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: Save these Instructions for the Local Electrical Inspectors use.
INSTALLER: Please leave these Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.

Take care when using cleaning agents or detergents.
Suitable for use in household cooking area

WARNING - To reduce the risk of fire or electric shock, do not use this fan

with any Solid-State Speed Control Device.

CA UTION - To reduce risk of fire and to properly exhaust air, be sure to duct air

outside – Do not vent exhaust air into spaces within walls or ceilings or into
attics, crawl spaces, or garages.

CA UTION - For general ventilating use only. Do not use to exhaust hazardous or

explosive materials and vapors.

USA

CAUTION - To avoid motor bearing damage and noisy and/or unbalanced impellers,

keep drywall spray, construction dust, etc. off power unit.

CAUTION - Please read specification label on product for further information and

requirements.

W ARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY

TO PERSONS, OBSERVE THE FOLLOWING:

A. Use this unit only in the manner intended by the manufacturer. If you have ques

tions, contact the manufacturer.

B. Before servicing or cleaning unit, switch power off at service panel and lock the

service disconnecting means to prevent power from being switched on acciden­tally. When the service disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the service panel.

WARNING - TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:

A. Never leave surface units unattended at high settings. Boilovers cause smok-

ing and greasy spillovers that may ignite. Heat oils slowly on low or medium

- 5 -

settings.

B. Always turn hood ON when cooking at high heat or when flambeing foods ( i.e.

Crepes Suzette, Cherries Jubilee, Peppercorn Beef Flambè ).

C. Clean ventilating fans frequently. Grease should not be allowed to accumulate

on fan or filter.

D. Use proper pan size. Always use cookware appropriate for the size of the

surface element.

E. Keep fan, filters and grease laden surface clean.
F. Use high range setting on range only when necessary.Heat oil slowly on low to

medium setting.

G. Don’ t leave range unattended when cooking.
H. Always use cookware and utensils appropriate for the type and amount off food

being prepared.

W ARNING – TO REDUCE THE RISK OF INJURY TO PERSONS IN THE EVENT

OF A RANGE TOP GREASE FIRE, OBSERVE THE FOLLOWING:

A. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or metal tray, then turn

off the burner. BE CAREFUL TO PREVENT BURNS. If the flames do not go out
mmediately, EVACUATE AND CALL THE FIRE DEPARTMENT.

B. NEVER PICK UP A FLAMING PAN – You may be burned.
C. DO NOT USE WATER, including wet dishcloths or towels – a violent steam explo

sion will result.

D. Use an extinguisher ONLY if:

1. You know you have a Class ABC extinguisher, and you already know how to

perate it.

2. The fire is small and contained in the area where it started.

3. The fire department is being called.

4. You can fight the fire with your back to an exit.

Proper maintenance of the Range Hood will assure proper performance of
the unit.

INST ALLATION INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR IN-

JURY TO PERSONS, OBSERVE THE FOLLOWING:

A. Installation work and electrical wiring must be done by qualified person(s) in

accordance with all applicable codes and standards, including fire-rated construc­tion.

B. Sufficient air is needed for proper combustion and exhausting of gases through

the flue (chimney) of fuel burning equipment to prevent back drafting. Follow the
heating equipment manufacturer’s guideline and safety standards such as those
published by the National Fire Protection Association (NFPA), and the American
Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE),
and the local code authorities.

- 6 -

C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and

other hidden utilities.

D. Ducted fans must always be vented to the outdoors.
E. This unit must be grounded.

WARNING - TO REDUCE THE RISK OF FIRE, USE ONLY METAL DUCTWORK.

WARNING - UNDER CERTAIN CIRCUMSTANCES DOMESTIC APPLIANCES

MAY BE DANGEROUS.

A. Do not check filters with hood working.
B. Do not touch the lamps after a prolonged use of the appliance.
C. No food must be cooked flambè underneath the hood.
D. The use of an unprotected flame is dangerous for the filters and could cause

fires.

E. Watch constantly the fried food in order to avoid the cooking oil flares up.
F. before performing any mainteinance operation, disconnect the hood from the

electrical service.

The manufacturers will not to accept any responsability for eventual damages,

because of failure to observe the above instructions.

- 7 -

INST ALLATION INSTR UCTIONS
OPERA TING INSTRUCTION

READ AND SAVE THESE INSTRUCTIONS

GENERAL

• Carefully read the following important information regarding installation safety and main-

tenance. Keep this information booklet accessible for further consultations.
The appliance has been designed for use in the ducting version (air exhaust to the outside
– Fig.1).

INST ALLATION INSTR UCTIONS

• Power Suppl y Connection

For connection to the power supply refer to the follows fig.6 :

BLACK = L line
WHITE = N neutral
GREEN / YELLO W = G ground

A double-pole switch properly rated must be installed to provide the range hood power
supply disconnection.

The appliance must be installed at a minimum height of 26 inches (66 cm) from an electric
cooker stove, or 30 inches (76 cm) from gas or combined cooker stoves. If a connection
ductwork composed of two parts is used, the upper part must be placed outside the lower
part. Do not connect the range hood exhaust duct air to the same duct air used to exhaust
hot air or fumes from other appliances other than electrical. Before proceeding with the
assembly operations, remove the anti-grease filter(s) (Fig.5) so that the unit is easier to
handle.

• FIXING TO THE W ALL

Drill the holes A respecting the distances indicated (Fig.2). Fix the appliance to the
wall and align it in horizontal position to the wall units. When the appliance has been
adjusted, definitely fix the hood using the screws A (Fig.4). For the various installa­tions use screws and screw anchors suited to the type of wall (e.g. reinforced con­crete, plasterboard, etc.). If the screws and screw anchors are provided with the
product, check that they are suitable for the type of wall on which the hood is to be
fixed.

• FIXING THE DECORATIVE TELESCOPIC FLUE

Arrange the electrical power supply within the dimensions of the decorative flue.
Prepare the air exhaust opening. Adjust the width of the support bracket of the upper
flue (Fig.3). Then fix it to the ceiling using the screws A (Fig.3) in such a way that it
is in line with your hood and respecting the distance from the ceiling indicated in
Fig.2. Connect the flange C to the air exhaust hole using a connection pipe (Fig.4).
Insert the upper flue into the lower flue and rest above the frame. Extract the upper
flue up to the bracket and fix it with the screws B (Fig.3).

- 8 -

USE

• If the apparatus is equipped with the following controls (fig.7A):
A = OFF
B = SPEED I
C = SPEED II
D = SPEED III
E = LIGHT

• If the apparatus is equipped with the following controls (fig.7B):
A = LIGHT
B = OFF
C = SPEED I
D = SPEED II
E = SPEED III
F = AUTOMATIC STOP TIMER - 15 minutes

• If your appliance does have the INTENSIVE speed function, press key E for two seconds

and it will be activated for 10 minutes after which it will return to the previously set speed.
When the function is active the LED flashes. To interrupt it before the 10 minutes have
expired press key E again.

• By pressing key F for two seconds (with the hood switched off) the “clean air” function is
activated. This function switches the appliance on for ten minutes every hour at the first
speed. As soon as this function is activated the motor starts up at the first speed for ten
minutes, During this time key F and key C must flash at the same time.
After ten minutes the motor switches off and the LED of key F remains switched on with a
fixed light until the motor starts up again at the first speed after fifty minutes and keys F
and C start to flash again for ten minutes and so on.
By pressing any key for the exclusion of the hood light the hood will return immediately to
its normal functioning (e.g. if key D is pressed the “clean air” function is deactivated and
the motor moves to the 2nd speed straight away. By pressing key B the function is deac-
tivated).

• The “automatic stop timer” delays stopping of the hood, which will continue functioning for
15 minutes at the operating speed set at the time this function is activated.

• Active carbon/grease filter saturation:

- When button A flashes at a frequency of 2 seconds, the grease filters must be
cleaned.

- When button A flashes at a frequency of 0.5 seconds, the carbon filters must be
replaced.
After the clean filter has been replaced, the electronic memory must be reset by
pressing button A for approximately 5 seconds, until the light on the button stops
flashing.

- 9 -

MAINTENANCE

• It is recommended to operate the appliance prior to cooking. It is recommended to leave

the appliance in operation for 15 minutes after cooking is terminated in order to completely
eliminate cooking vapours and odours. The proper function of the cooker hood is condi­tioned by the regularity of the maintenance operations.

• The anti-grease filters capture the grease particles suspended in the air, and are therefore
subject to clogging according to the frequency of the use of the appliance. In order to
prevent fire hazard, it is recommendable to clean the filter at a maximum of 2 months by
carrying out the following instructions:

- Remove the filters from the cooker hood and wash them in a solution of water and neutral
liquid detergent, leaving to soak.

- Rinse thoroughly with warm water and leave to dry.

- The filters may also be washed in the dishwasher.
The aluminium panels may alter in colour after several washes. This is not cause for
customer complaint nor replacement of panels.

• Clean the fan and other surfaces of the cooker hood regularly using a cloth moistened
with denatured alcohol or non abrasive liquid detergent.

FUSE

• The halogen lamps circuit is controlled by a fuse 5x20 mm, 125V 5A. In case of neces-

sity it can be replaced only by specialized personnel.

- 10 -