Elinz CR11 Operating Instructions Manual

11” ROOF MOUNT DVD

There maybe a few bright or dark spots on the screen when it plays
which is a very common phenomenon in active matrix display
technology. It does not indicate any fault or problem.

- 16 -

www.elinz.com.au

[e-mail]
1300 881 773

www.elinz.com.au

[e-mail]
1300 881 773

Simple Trouble-shooting

Problems

Possible Reasons

No sound and picture

 AC adaptor or car adaptor is not

properly connected.

 Unauthorized power supply is used.
 The power switch is in OFF mode.

No Picture

 The channel selection is not done

properly.

 Resetting the broadcast channels.

No Sound

 The volume is turned OFF.
 The Audio sets are set in a wrong way.
 The broadcast signal is too weak.

Poor Reception

 The Antenna is not adjusted properly.
 The channels are not tuned properly.

Dark Picture

 The brightness and contrast is not

adjusted properly.

 Cold environment temperature.

Punch-drunk or unstable picture

 The antenna is not adjusted properly.
 Weak TV Signal

Jitters

 The Antenna direction is incorrect
 The TV maybe receiving reflecting

signals from buildings or mountains in
the area.

Snowflake

 The TV maybe receiving electronics or

electromagnetic interference when car
engineers trains high voltage wires or
neon signs

Poor Colour

 The colour is not properly adjusted.
 Weak Signal

No Power Supply of No Voice

 Electric wire Conjunction inaccuracy.
 Check line connections
 The fuse breaks: Replace with

compatible fuse specification.

The CD has already inserted but no sound

 Press the CD to its right direction

and make its label in an upward
exposure.

 The Disc become soiled or row to

harm seriously;

 Clean the CD or replace with a

new Disc

The vibration caused emergency jump to

the sound phenomenon

 Unsteady installation; (Use

gearing parts to install this
machine firmly.

 Clean the CD or replace with a

new Disc.

Have no vibration appearing with the sound

phenomenon.

 The CD is dirty or damaged,

Please clean or replace the CD.

Cautions:

1. Keep the machine from rain or damp to avoid fire and electric shock.

2. Do not try to repair the device by yourself. Please switch off the

machine immediately and inform our factory or dealers if there’s any

problem. This product is comprised of many electronic components.
Disassembling or self-renovating without a professional guidance can
cause machine damage.

3. Do not expose machine to moisture, dust, vapour, oil smog, direct

sunlight or influential environment.

4. Do not use thinner or other chemical detergents in cleaning the

machine. Use a soft cloth to remove dust or dirt on the machine.

5. Keep the machine away from very cold or very hot temperature

environments. Note: the machine’s storage temperature ranges - 10
degrees Celsius ~ 60 degrees Celsius and its operating temperature is
0 degrees Celsius ~ 40 degrees Celsius.

6. Only play compatible Discs. This machine can only play DVD/CD-R/CD-

RW/SVCD/VCD/DVCD/CD/MP3/MP4/JPEGS, receive TV signal with
built it tuner.

7. Avoid dropping or large impact to the machine.

8. For your safety, do not turn on/ watch or operate the machine while

driving. In some countries and regions it’s against the law.

9. Safe power supply : DC 12V(10V-14V)

Attention:

- 15-

www.elinz.com.au

[e-mail]
1300 881 773

www.elinz.com.au

[e-mail]
1300 881 773

Table of contents

Functions and Features ---------------------------------------------------1

Appearance and Functions ---------------------------------------------- 2

Wiring Diagram ------------------------------------------------------------- 3

Installation -------------------------------------------------------------------4

Remote Control Panel ---------------------------------------------------- 5

The Remote control battery Installation sketch map ------------5

Method of operating DVD System ------------------------------------ 6

How to Setup DVD Menu ------------------------------------------------7

How to setup TFT Menu ------------------------------------------------ 13

USB/SD Function Description ----------------------------------------- 15

Simple Trouble Shooting ----------------------------------------------- 16

USB/SD Function Description

1. Entrance: When entering to DVD state, press USB/SD button on the

remote control board unit to process
(Please press the “Stop” button to enter the
above transformation if the DVD is in read state)

2. Withdraw: When in USB/SD working pattern, press “Stop” button and

press USB/SD button again then transfer to DVD working pattern
again.

- 14 -

- 1 -

www.elinz.com.au

[e-mail]
1300 881 773

www.elinz.com.au

[e-mail]
1300 881 773

Functions and Features

 DVD/TV
 Super slim design, perfect combination of crystal glass panel and

roof mount style

 Digital technology, clear picture with no interference
 Auto channel search, auto store and full channel receive
 Frequency range : FM87.7 – 89.2MHz
 IR transmitter earphone output
 Audio/Video Input and Output
 Full-function remote control
 With USB / SD
 Built-in Speaker
 Screen Size : 11 Inches (16.9)
 With game
 Pixel : 800(W) x RGB x 480(H)
 Power: about 20W