eLine Technology EVC-Z User Manual

Page 1
ELI-EVC-Z Motor Zoom Camera Menu
u
ELI-EVC-Z - Zoom Camera with Auto Focus
eLineTechnology.com
Page 1
eLineTechnology.com
MAIN MENU
1.FOCUS SETUP
1-1 FOCUS TYPE 1-3 RETURN
AUTO: AUTO FOCUS MANUAL: MANUAL FOCUS Return to the previous men
1-2 DISPLAY ZOOM TIMES 1-4 EXIT MENU ON: ZOOM Display ZOOM Times OFF: ZOOM Turn off Display of ZOOM Times EXIT MENU
2.IR LED SETUP
2-1 DAY NIGHT SWITCH ON: OFF: 2-2 BURST OFF AT NIGHT ON: OFF:
Page 2
3.PROTOCOL SETUP
ELI-EVC-Z - Zoom Camera with Auto Focus
eLineTechnology.com
Page 2
RS485 PROTOCOL Setup
After turn PTZ OSD will display 485 baud rate, address, protocol, and other information, as shown below:
P: PAL 03X: ZOOM Software Version 09: Software Version
The setup status of PTZ
DVR or controller 485 set the same as PTZ, then you can PTZ control. Change RS485 PROTOCOL Setup: IRIS-OPEN MAIN MENU Press IRIS-OPEN Key to Enter MAIN MENU
3-1 PROTOCOL: PELCO-D/P PROTOCOL you can choose PELCO-D or PELCO-P
3-2 ADDRESS: 1-255 Address setup: 1-255
3-3 BAUDRATE: 1200BPS/2400BPS/4800BPS/9600BPS 4 Baud rate choose: 1200BPS/2400BPS/4800BPS/9600BPS
Page 3
3-4 255 (06)
ELI-EVC-Z - Zoom Camera with Auto Focus
eLineTechnology.com
Page 3
Using address255,You can control all the same protocols and baud rate connected with the DVR 485 but the address is different from the PTZ.
Using address 255 control,press IRIS-OPEN Enter OSD choose PAN TILT SETU Submenu,RETURN will become RANDOM ADDRESS
When you are in RANDOM ADDRESS press IRIS-OPEN key Will create a random address, such as the right address 026
Has this feature the user do not set address before install PTZ, 255 address after installation can also be used to control and select RANDOM ADDRESS to creat random addresses, in this way, multiple head connected with the DVR and 485 will have a different address,And then use the new address can be controlled separately.
4.RESET MENU SETUP
4-1 RESET MENU SETUP SET Recovery PTZ menu settings to the factory default
4-2 FACTORY DEFAULT SET SET Recovery PTZ preset positions, 485 set to to the factory default
Loading...