ESTR 200
User Guide
Voltages is AC 120V,60Hz.
IMPORTANT SAFETY INSTRUCTIONS
Set up and Maintenance of the Receiver
15cm/6"
10cm/
4"
10cm/
4"
Provide spaces for sufficient ventilation as
indicated:
Do not connect to the AC power cords until all
are completed.apparatus
Do not use your receiver immediately after
transferring it from a cold place to a warm place:
there is risk of condensation.
Do not expose your receiver to water and
excessively high temperatures.
After having disconnected your receiver, clean
the case with a soft cloth, or with a slightly damp
leather chamois. Never use strong solvents.
Protect your receiver from Overheating
Do not block ventilation holes in any .
Arrange receiver so that air can circulate
freely.
apparatus
the
Do not stack receiver directly on top of each
other.
the
Allow adequate ventilation when placing your
receiver a stand.
Place an amplifier near the top shelf of the stand
so heated air rising from it will not affect other
. If you have a satellite receiver, you
should place it on the top shelf.
apparatus
10cm/
4"
15cm / 6"
15. Cleaning - Unplug this unit from the wall outlet
before cleaning. Do not use liquid cleaners or
aerosol cleaners. Use a damp cloth for cleaning.
16. Power lines - An outdoor antenna should be
located away from power lines.
17. Object and Liquid Entry - Care should be taken
so that objects do not fall and liquids are not spilled
into the enclosure through openings.
13.Unplug this apparatus during lighting storms or
when unused for long periods of time.
14.Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way. Such as power-supply cord or
plug is damaged, liquid has been spilled or objects
have fallen into the apparatus. The apparatus has
been exposed to rain or moisture. Does not operate
normally or has bee dropped.
IMPORTANT SAFETY INSTRUCTIONS
CONTENTS
1
Table of Contents
Equipment specifications
Troubleshooting tips
13
14
Care and maintenance
13
Receiver controls & functions
Remote control
Front panel
Display messages
Tuning the receiver
7
8
9
9
7
Unpack the receiver
About remote control
Basic connections
Connecting the speakers
Connecting for power
Using headphones
First things
2
2
3
4
5
6
6
Real panel
Before you connect
Connecting a compact disc player
11
12
12
11
Connecting auxiliary components
Indoor FM antenna
AM loop antenna
One receiver unit
2
One Remote Control
Unpacking the receiver
You should receive the following items:
FIRST THINGS
Installing batteries in the remote control
1. Open the battery compartment cover.
2. Insert the supplied batteries ( AA, R6) in the
correct direction by aligning the + and marks on
the batteries with the polarity marking (+ and -) on
the inside of the battery compartment.
3. Replace the cover by pressing until it snaps into
place.
Change all of the batteries if you notice the
condition like: the operation range of the remote
control decreases, the indicator does not flash
or light becomes dim.
Do not use old batteries together with new ones.
Do not use different types of batteries together.
If the batteries have leaked, dispose of them
immediately. Avoid touching the leaked material
or letting it come into contact with clothing, etc.
Clean the battery compartment thoroughly before
installing new batteries.
Remote controller operation range
Approximately
6m(19.7feet)
30
30
About remote control
3
Notes
FIRST THINGS