Eleiko POWERLIFTING SQUAT STAND/BENCH Installation Instruction
ELEIKO POWERLIFTING
SQUAT STAND/BENCH
Art.no. 3060892-XX
CAUTION
The equipment must be installed and used in a place whose access and supervision
are specifically controlled by the owner.
Be sure to install the equipment on a stable base and properly level the equipment.
ELEIKO recommends that all equipment is secured to floor and installed by a licensed
contractor or an ELEIKO-installer.
SAFETY INSTRUCTIONS
It is the responibility of the purchaser of ELEIKO products to instruct all users and
supervising personnel on proper usage of the equipment.
1.
All included warnings (labels) and instructions
MUST
be read before the use of any
ELEIKO-equipment. Use each equipment as it is intended for.
2.
A user
MUST
get a medical examination and proper instructions before the use of
any ELEIKO-equipment.
3.
DO NOT
let anyone, under any cuircumstances, use equipment that appears to be
damaged. Do not try to repair any equipment before consulting an ELEIKO technician.
4.
DO NOT
replace the components of ELEIKO-equipment with other none ELEIKOÂequipment (magnetic safety pin, frames, bars), do not improvise. If there are any
doubts consult an ELEIKO representative prior to any intervention.
5.
DO NOT
overload the equipment and
DO NOT
try to exceed personal strength
levels.
6.
Children under the age of 14 must be supervised by an adult.
7.
DO NOT
remove any safety labels from the ELEIKO-equipment. ELEIKO is not
responsible if a label is removed. Replace damaged labels immediately.
PREVENTITIVE MAINTENANCE & INSPECTIONS
DAILY:
Cleaning of upholstery.
REGULARLY:
Clean the surfaces on frames and tubes from dust and dirt.
Check that all bolts between parts, walls, floors are properly tightened, according to
recommendations.
ADDITIONAL INFORMATION
This equipment is for indoor use only.
READ BEFORE INSTALLATION AND USE
Nut M12
x2
Small parts
x2
M12 x 100
Washer 10
x10
M10 x 25
x10
Knob internal thread
x2
Knob externa thread
x4
Washer 6
x6
x6
M6 x 25
Assembly section
x1
Safety pin
x6
Tools needed:
Hex Key 6 mm
Hex Key 4 mm
Wrench 19 mm (x2)
CONTENTS
Loading...