EleCycles SMA-Q Installation Instructions Manual

Installation Instructions

1 / 12 www.elecycles.com

Installation Instructions

1 Rim Installation

1.1 Flywheel Installation

Remove the nuts and sensor cap from the cassette.

Install the cassette flywheel and lock the flywheel with the sensor cap. Note
that it must be installed with the flywheel sensor cap of the system, otherwise
there is no power output.

Installation Instructions

2 / 12 www.elecycles.com

Screw the nut to the innermost.

Installation Instructions

3 / 12 www.elecycles.com

1.2 Disc brake Installation (if V brake, just skip

this step)

Remove the plastic gasket indicated by the arrow (take care of the 6 screws)

Install the disc brake using the 6 screws in previous step.

Note that it is necessary to use the disc break screws from the motor, using
other disc brake screws may cause the motor unable to work due to the
excessive length of the screws.

Installation Instructions

4 / 12 www.elecycles.com

1.3 Tire installation

Install the tire cushion

Install inside and outside tire, be careful to install according to the direction of
the tire.