Electro-Voice EVID-P6.2B, EVID-P6.2W Installation Manual
EVID Pendant Speaker
EVID‑P6.2B | EVID‑P6.2W
en
Installation manual
EVID Pendant Speaker Table of contents | en 3
Electro-Voice Installation manual 2018.09 | 03 | F.01U.358.439
Table of contents
1
Safety 4
1.1 Notices 4
2
Introduction 6
2.1 Product information 6
2.2 Packing list 7
2.3 Pendant suspension cable 7
3
Installation 8
3.1 Installing with the threaded rod adapter – optional accessory 10
3.2 Installing the weather cover – optional accessory 11
4
Wiring 13
4.1 Step 1 – Attach wiring to the terminal connector 13
4.2 Step 2 – Adjust tap selector 14
4.3 Step 3 – Attach the grille 14
5
Troubleshooting 16
6
Technical data 17
4 en | Safety EVID Pendant Speaker
2018.09 | 03 | F.01U.358.439 Installation manual Electro-Voice
1 Safety
!
Warning!
Suspending any object is potentially dangerous and should only be attempted by individuals
who have a thorough knowledge of the techniques and regulations of suspending objects
overhead. Electro-Voice strongly recommends that loudspeakers be suspended taking into
account all current national, federal, state, and local laws and regulations. It is the
responsibility of the installer to ensure all loudspeakers are safely installed in accordance
with all such requirements. When loudspeakers are suspended, Electro-Voice strongly
recommends the system be inspected at least once per year or as laws and regulations
require. If any sign of weakness or damage is detected, remedial action should be taken
immediately. The user is responsible for making sure the wall, ceiling, or structure is capable
of supporting all objects suspended overhead. Any hardware used to suspend a loudspeaker
not associated with Electro-Voice is the responsibility of others.
Suspension cable important safety instructions:
Load - Do not exceed the WLL (Working Load Limit) of the pendant suspension cable.
The WLL of the pendant suspension cable is 10 kg (22 lb).
No lifting - Do not use for lifting, such as in a crane or pulley situation.
No movement - The pendent suspension cable is to be used to suspend static loads only. Do not
use the cable to suspend moving objects or objects likely to be subject to
movement.
No joining - Do not splice together the pendent suspension cable with another cable or
other joining device. The pendent suspension cable as supplied is the maximum
length available and should not be altered in any way.
Not for re-use - Do not re-use the pendent suspension cable; it is designed for permanent fixed
installation use only.
Lubricants - Do not apply oil or any other lubricant to any part of the assembly.
Round duct/pipes - When wrapping around duct or other round pipes, do not exceed an angle of 60
degrees between the top of the pipe and the pendent suspension cable.
I-Beams - Minimum radius on I-Beams to be no less than 1/8-inch.
Corners/edges - Cables in contact with corners, edges, protrusions, or abrasive surfaces shall be
protected with a material of sufficient strength, thickness, and construction to
prevent damage.
1.1 Notices
Old electrical and electronic appliances
Electrical or electronic devices that are no longer serviceable must be collected separately and
sent for environmentally compatible recycling (in accordance with the European Waste
Electrical and Electronic Equipment Directive).
To dispose of old electrical or electronic devices, you should use the return and collection
systems put in place in the country concerned.
EVID Pendant Speaker Safety | en 5
Electro-Voice Installation manual 2018.09 | 03 | F.01U.358.439
Copyright and disclaimer
All rights reserved. No part of this document may be reproduced or transmitted in any form by
any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior
written permission of the publisher. For information on getting permission for reprints and
excerpts, contact Electro-Voice.
All content including specifications, data, and illustrations in this manual are subject to change
without prior notice.
6 en | Introduction EVID Pendant Speaker
2018.09 | 03 | F.01U.358.439 Installation manual Electro-Voice
2 Introduction
The EVID-P6.2 Pendant Loudspeaker provides a convenient way to equip open ceiling spaces
with sound where conventional surface or ceiling mount speakers cannot be used. It’s ideal
for use in a wide variety of environments and spaces to provide background speech and
music.
The EVID-P6.2 Pendant Loudspeaker is UL1480A and CSA C22.2 certified for indoor
installations and protected outdoor installations.
Read through this manual to familiarize yourself with the safety information, features, and
applications before you use these products.
2.1 Product information
A
D
C
B
F
I
J
H
G
E
Figure2.1: Product identification
Item Component
A Pendant speaker
B Input terminal
C Secondary auxiliary support
D Main suspension tab
E Tap selector
F Grille (installed)
G Grille removal tool
H Pendant suspension cable
I Coupler
J Support hanger
Loading...