Electro-voice DO-1 DATASHEET

Technische Informationen Engineering Data Sheet Informations techniques
DO-1
NetMax Digital Output Module
Beschreibung Description Description
Das DO-1 ist ein 8-kanaliges Digi­tal-Ausgangsmodul für den NetMax System Controller. Der Anschluss für digitale Audio-Ausgangssignale im AES/EBU Format (48 kHz Abta­strate) erfolgt an verschraubbaren Euro-Block Steckverbindern. Die interne Signalverarbeitung erfolgt in 48 Bit Wortlänge.
Weitere DO-1 Eigenschaften:
144 dB Dynamikbereich - für beste Audio-Performance ohne störende Nebengeräusche.
Automatische Konfiguration ­Meldung in IRIS-Net, wenn neues Modul bestückt wurde bzw. wenn Modul entfernt wurde.
Inhalt Contents Contenu
1 x Technische Informationen DO-1 1 x DO-1 Modul 4 x Stecker 3-pol., Phoenix MC 1.5 3-STF-3.81 (Nr. 18 27 71 6) 2 x Schrauben Kombi-Torx M3x10
The DO-1 is an eight-channel dig­ital output module for the NetMax System Controller. Digital audio signals in AES/EBU format are connected via screw-lockable Euro block connectors. Internally the sig­nals are processed in 48-bit word length.
Additional DO-1 features:
144 dB dynamic range - for best audio performance.
Automatic configuration - indi­cation (message) of installation and removal of modules via IRIS­Net software.
1 x Engineering Data Sheet DO-1 1 x DO-1 module 4 x Connector 3-pole, Phoenix MC
1.5/3-STF-3.81 (Nr. 18 27 71 6)
2 x Screws Combination Torx
M3x10
Le DO-1 est un module de sortie numérique huit canaux pour le Contrôleur Système NetMax. Les signaux audio numériques au for­mat AES/EBU sont reliés via des connecteurs Euro Block à vis. En interne les signaux sont traités avec une résolution de 48 bits.
Autres caractéristiques du DO-1:
Dynamique de 144 dB - pour de meilleures performances audio.
Configuration automatique ­indication (message) d'installa­tion et de suppression des modu­les via logiciel IRIS-Net..
1 x Informations techniques DO-1 1 x Module DO-1 4 x Connecteur 3 pôles, Phoenix
MC 1.5/3-STF-3.81 (n° 18 27 71 6)
2 x Vis Combination Torx M3x10
Slot Connector
+5V DIGITAL SUPPLY
+3.3V
MCLK
WCLK
SPI
RES
SERIAL
AUDIO
DATA
SLOT ID
4
DO-1 Block Diagram
CLOCK
DIVIDER
SERIAL
DATA
SELECT
MODULE
TYPE
DSP
4 CHANNEL
DIGITAL OUTPUT TRANS­MITTER
+
-
+
-
+
-
+
-
OUT 1 CH 1/2
AES/EBU
OUT 2 CH 3/4
AES/EBU
OUT 3 CH 5/6
AES/EBU
OUT 4 CH 7/8
AES/EBU
Technical Specifications
Supply Voltage / Current +3.3 V DC, ± 0.3 V / 130 mA
+5 V DC, ± 0.3 V / 100 mA
Digital Audio Outputs
Output Format AES/EBU Professional Format
Output Impedance 110 Ω
Frequency Response 20 Hz...20 kHz (±0.1 dB)
Signal to Noise Ratio (A-weighted) 144 dB typical
THD+N < 0.00002 %
Output Sample Rate 48 kHz
Data Format 24 Bit linear, 48 Bit processing
Signal Delay 0.0625 ms
Operating Temperature Range 0 °C...40 °C
Dimensions (W x H x D) 114 x 33 x 258.5 mm
Weight 170 g
Montage Installation Installation
1. Gerät ausschalten und Netz­stecker abziehen
2. Leerblende an Rückwand abschrauben (2 Schrauben hin­ten)
3. DO-1 Modul in gewünschten Slot einschieben und mit 2 Schrauben an Rückwand befe­stigen (siehe Abbildung)
4. Netzkabel einstecken und Gerät einschalten
5. DO-1 Modul wird im Gerät auto­matisch erkannt.
Nun stehen 8 neue digitale Aus­gänge zur Verfügung.
1. Turn off the power of the unit and pull the mains plug
2. Remove the blind on the rear panel (2 screws)
3. Insert the DO-1 module in the desired slot and secure it with 2 screws on the rear panel (see picture)
4. Plug in the mains cord and turn the unit’s power on
5. The unit automatically recog­nizes the DO-1 module.
Eight additional digital outputs can now be used.
1. Mettez l'unité hors tension et débranchez-la du secteur
2. Enlevez le cache situé à l'arrière (2 vis)
3. Insérez le module DO-1 dans le slot désiré et fixez-le sur le pan­neau arrière à l'aide des 2 vis (voir illustration)
4. Branchez le cordon secteur et mettez l'unité sous tension
5. L'unité reconnaît automatique­ment le module DO-1
Huit nouvelles sorties numériques sont désormais à votre disposition.
Verbindungskabel Euro-Block ­XLR für DO-1 Audio-Ausgänge
Interconnection cord Euro block
- to - XLR for DO-1 digital outputs
Cordon d'interconnexion Euro Block/XLR pour les sorties numériques AES/EBU du DO-1
Abmessungen / Dimensions
114
GmbH • Hirschberger Ring 45 • 94315 Straubing • Telefon (09421) 706-0 • Telefax (09421) 706-265 Subject to change without prior notice. Printed in Germany V1.0 26.02.2008 D 362 778
Loading...