Electro-Voice Co7 User Manual

COBALT

™

WIRED

MICROPHONES

General Product Description

The Co7 is the perfect choice for the performer who wants
hassle free sound – a mic that performs in high volume
situations without feedback. Built to the same standards of
EV’s N/DYM microphones, this mic’s low handling noise
also makes it ideal in critical acoustic settings.

Microphone Use and Placement

Please note that miking techniques are a matter of personal
preference. These are merely guidelines to assist in the
placement of the microphone to gain optimal performance.

Usage Optimal Placement

Vocals

Zero to six inches from the windscreen,
and on axis with the microphone.

Spoken Word Five to ten inches from the windscreen,

and on axis with microphone

Standard Placement & Use Guidelines

1. Always point the microphone at the desired source of
sound, and away from any unwanted sources.

2.The microphone should be located close to the sound
source to minimize interference from other potential
sound sources.

3. Use the 3-to-1 rule when using multiple microphones.
Place each microphone three times farther from other
microphones as from the desired sound source.

4. Minimize over-handling of the microphone to reduce
unwanted mechanical noise.

5.Working close to the microphone will increase the bass
tone and also provide increased gain-before-feedback.

Cobalt™Co

7

Crossroads Vocal Microphone

Cobalt™Co

7

Crossroads Vocal Microphone

Specifications

Element Dynamic

Neodymium magnet structure

Frequency Response 50 Hz to 18 kHz

Polar Pattern Cardioid

Impedance Low-Z balanced (600 Ohms)

Sensitivity

Open Circuit Voltage 3.2 mV/PA (-50 dBV) re 1 Pa*

1 Pa = 94 dB SPL

Microphone Connector 3-pin, XLR-type

Polarity Pin 2 positive, referenced to pin 3

with positive pressure on diaphragm

Finish Durable polyurethane paint

Materials Die cast zinc housing

Dimensions

Length 6.7 in. (170 mm)
Diameter 2.1 in. (53 mm)
Shank .85 in. (22 mm)

Weight

Net 11.7 oz. (332 grams)
Shipping 29.8 oz. (845 grams)

Accessories included Stand adaptor (black)

Gig bag

12000 Portland Avenue South, Burnsville, MN 55337
Phone: [phone], Fax: [phone]

www.electrovoice.com

© Telex Communications, Inc. 9/2003

Part Number 38109-895 Rev. B

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: [phone]

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212

For warranty repair or service information, contact the Service Repair department at:

800/553-5992 or 402/467-5321

For technical assistance, contact Technical Support at:

800/392-3497 or 952/736-4656

Specifications subject to change without notice.