Electrorad Digi-Line DE Series Installation And Operating Instruction Manual

Electrorad Digi-Line

Installation, Operating & Instruction Manual

ELECTRORAD UK LTD

Unit 1, Clayton Park, Clayton Wood Rise, West Park, Leeds, LS16 6RF
T: 0844 479 0055, [e-mail], www.electrorad.co.uk

After Sales Service:

ELECTRORAD UK LTD

T: 0844 479 0055, [e-mail]

Class 1 - 230V - 50 Hz

01.01.2018

03

Electrorad Digi-Line

1.0 Warnings & Safety Information

Contents

1.0 Warnings & Safety Information 03

2.0 General Information 05

3.0 Installation 06

4.0 Maintenance, Repair & Disposal 07

5.0 Waste Disposal According to The WEEE Directive (2002/96/EC) 08

6.0 Warranty 08

7.0 Operating Instructions 08

7.1 Display 08

7.2 Behaviour Indicator 09

7.3 Keyboard 09

8.0 Working Mode Definition 09

8.1 Manual Comfort Mode 09

8.2 Manual Reduced Mode 09

8.3 Frost Protection Mode 09

8.4 Standby Mode 10

8.5 Automatic Mode 10

8.6 How To Set The Time 10

8.7 Programme Selection Mode 11

8.8 Defining a User Programme 11

8.9 Wireless Programmer 14

8.10 Timed Override Mode 15

8.11 Power Settings 15

8.12 Sensor 15

9.0 Key Lock Function 15

10.0 Window Open Function 16

11.0 Parameter’s Menu 16

12.0 Technical Characteristics 19

13.0 Troubleshooting & Solution 20

14.0 Preset Programmes 21

15.0 Eco Directive Characteristics 22

SAFETY INFORMATION

This appliance can be
used by children aged
from 8 years and above
and persons with reduced
physical, sensory or
mental capabilities or
lack of experience and
knowledge, if they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and understand
the hazards involved.

Children shall not play
with the appliance.
Cleaning and user
maintenance shall not be
made by children unless
they are older than 8 and
supervised.

Keep the appliance and
its cord out of reach of
children aged less than
8 years.

Children of less than
3 years should be kept
away from the unit unless
continuously supervised.

Children aged from
3 years and less than
8 years shall only switch
on/off the appliance
provided that it has been
placed or installed in
its normal operating
position and they have
been given supervision
or instruction concerning
use of the appliance in a
safe way and understand
the hazards involved.

Children aged from
3 years and less than
8 years shall not plug
in, regulate, clean the
appliance or perform
user maintenance.

05

Electrorad Digi-LineElectrorad Digi-Line

04

1.0 Warnings & Safety Information (cont...) 1.0 Warnings & Safety Information (cont...)

The radiator is filled with an exact amount
of environmental friendly vegetable oil. Any
repairs that require the radiator to be opened
shall therefore only be carried out by the

manufacturer or his approved agent. Please
contact Electrorad UK Ltd in case of leakage.

2.0 General Information

l

 The appliance is a sealed electric radiator

designed for fixed wall mounted installation.

l

 The radiator conforms to the standards EN

60 335-1 and EN 60 335-2-30.

l

 The radiator is class 1 and splash resistant

(IP44).

l

 The radiator complies with the European

Directive 2004/108/EC (CE Marking on all
radiators).

l

 The radiator is supplied complete with

power cable* and wall brackets.

l

 *A restricted range of radiators come with

a 3 pin plug.

CAUTION

Some parts of this
product can become very
hot and cause burns.
Particular attention has to
be given where children
and vulnerable people
are present.

In order to avoid
overheating, do
not cover the radiator.
“Do not cover” means
that the radiator must
not be used for drying
clothes, for example,
by placing them directly
on the radiator.

IMPORTANT SAFETY

INSTRUCTIONS!

Before starting work disconnect power supply!

All installation work and wiring work related
to the radiators, thermostats and programmers
must be carried out only when de-energised.

The appliance should be commissioned by
qualified professionals only.

Make sure to adhere to valid safety regulations.

Any repairs or maintenance within the warranty
period should be carried out only by approved
service engineers confirmed by Electrorad UK
Ltd.

For the correct installation of radiators it
is essential that the fixing of the radiator is
carried out in such a way that it is suitable
for intended use AND predictable misuse. A
number of elements need to be taken into
consideration including the fixing method
used to secure the radiator to the wall, the
type and condition of the wall itself, and
any additional potential forces or weights,
prior to finalising installation. IN ALL CASES

IT IS STRONGLY RECOMMENDED THAT
A SUITABLY QUALIFIED PROFESSIONAL
INSTALLER OR SIMILAR TRADESPERSON
CARRIES OUT THE INSTALLATION.

PLEASE NOTE: The fixing materials provided

are only intended for installation on walls made
of solid wood, bricks, concrete or on timber-frame
stud walls where the fixing is into the timber. All
walls being considered should have no more than
a maximum of 3mm wall finishing. For walls made
of other materials, for example hollow bricks,
please consult your installer and/or specialist
supplier. ONCE AGAIN, IF YOU ARE UNSURE,

IT IS STRONGLY RECOMMENDED THAT
A SUITABLY QUALIFIED PROFESSIONAL
INSTALLER OR SIMILAR TRADESPERSON
CARRIES OUT THE INSTALLATION.

The radiator is equipped with an overheat
protection that cannot be reset (melt fuse).
This overheat protection disconnects the
current if the radiator becomes too hot (e.g.
when covered).

If the supply cord is damaged, it must be
replaced by the manufacturer, his service
agent or similar qualified persons in order to
avoid a hazard.

1. Thermostat Control

3.

Room Temperature Sensor

Cable Hook Assembly

Back of Radiator

2. Power On/Off Switch

4.

Power Cable*

07

Electrorad Digi-LineElectrorad Digi-Line

06

3.0 Installation (cont...)

4.0 Maintenance, Repair & Disposal

l

 Use only a damp cloth for cleaning and

wiping of the radiator which should be
switched off at this time.

l

 When scrapping the radiator, follow the

regulations concerning the disposal of oil.

3.0 Installation

FLOOR

CONNECTION

l

 The electrical installation must comply with

the local or national regulations.

l

 The radiator must be connected to the

electrical supply, using a switched fused
spur with 3mm separation on all poles.

l

 If the radiator is installed in a bathroom or

shower room, it must be protected with a
residual current device (RCD) with a rated
residual current not exceeding 30 mA.

Optional Extras

A (min) 135 135 135 135 135 135 135

A (max) 160 160 160 160 160 160 160

B (min) 101 254 508 762 812 1016 1219

B (max) 152 305 558 812 863 1066 1270

Length (mm) 400 550 800 1050 1100 1300 1500

Electrorad Digi-Line Single Panel (refer to figure 2)

C 135 205

D 90 163

Height (mm) 300 500

A 160 160 160 160 160 160 160 160 160 160

B 101 203 355 508 660 711 965 1016 1320 1727

Length (mm) 400 500 650 800 950 1000 1250 1300 1600 2000

Electrorad Digi-Line Double Panel (refer to figure 2)

C 135 205

D 90 163

Height (mm) 300 500

l

 This product is splash resistant with an

IP44 rating. This must be considered when
installing in a location containing a bath or
shower, as defined by BS 7671.

l

 The radiator may be positioned in zone 2

(figure 4) of the bathroom, in so far as no
operating controls (button, switch, etc.) are
in reach of persons in the bath or under
the shower.

l

 NB: If the radiator is supplied with a

3 pin plug, then this should NOT be
installed in any bathroom zone.

FIXING

l

 Mark out the distance between the brackets

and the positions for the screw holes as
shown in figure 2 and the dimension tables
at the top of page 7, and ensure the safety
clips are used (see figure 3).

Figure 2.

Figure 3.

Figure 1.

Min. 100mm

Min. 100mm

Min. 100mm

Step 1 Step 2

POSITIONING

l

 The radiator must be positioned horizontally,

the right way up on the wall in order for it to
function correctly. Never switch the radiator
on in any other position as this will damage
the electrical element.

l

 The radiator must be positioned according

to the applicable standards and the
minimum distances as specified in figure 1
should be carefully observed.

l

 The radiator must not be located

underneath an electric socket.

Zone 1 Zone 2

Zone 2

Zone 0

OUTSIDE ZONES

3m

2.25m

0.6m

0.6m

Figure 4.

Safety Clip-on Brackets

RF Programmer + Touch E3

Electrorad Digi-Line radiators can be used
as a stand alone radiator. The radiator has
a built in radio frequency receiver which
can be used with an RF Programmer or
Touch E3. Please ask for more details.