Electronics Line 3000 EL2635 Users Manual
r
r
r
r
r
r
Introduction
The EL-2635 is a wireless repeater designed to extend
the range of wireless devices registered to the infiniti
control panel. Up to four repeaters can be registered to the
control panel with eight transmitters registered to each
repeater.
The repeater is powered by either 9VAC (via a
110VAC plug-in step down transformer) or 12VDC with a
6V rechargeable backup battery pack. Registration and
maintenance tests are performed using a plug-in LCD
programming keypad that provides a comprehensive
interface to the repeater.
Figure 1: Typical Single Repeater Application
Installation
1. Register all wireless devices to the infiniti control panel as explained in the infiniti installation manual.
2. On the control panel, define the detection devices that are intended to transmit via the repeater as follows:
• From the Programming menu, select Devices, Zones [911].
• Select the zone you want to program (1-32).
• From the zone’s sub-menu, select Repeater [#9].
• Select “Use Repeater”.
Note: It is not necessary to define, at the control panel, the keypads and keyfobs that are registered to the repeater.
3. Open the EL-2635’s plastic housing. To do so, remove the two cover screws and lift the front cover away from the base.
Antenna
Connecto
Uppe
Mounting
Hole
Transmitte
LED Indicator
Upper
Mounting
Hole
Flash Programming
Connector
Receive
Power Input
Terminals
AC Powe
Protection Fuse
Lowe
Mounting
Hole
Wiring
Hole
Figure 2: EL-2635 (cover removed)
Programming Keypad
Connector
Backup
Battery Pack
Battery Connector
Lower
Mounting
Hole
Tamper
Switch
4. Connect the antenna provided to the antenna connector.
5. Connect the backup battery pack to the Battery connector.
6. Connect 9VAC (via a 110VAC plug-in step down transformer) or a 12VDC transformer to the Power Input terminal block.
7. All registration and test functions, described in the following sections, are performed from
the LCD programming keypad shown in Figure 3. Connect the programming keypad to
the Programming Keypad connector.
Note: The programming keypad is not able to operate on battery power only.
8. Test the repeater from the required mounting location before permanently mounting the unit.
9. Mount the base to the wall using four screws and replace the front cover.
When the tamper switch is open, the bi-color LED provides indication regarding repeater transmission
and reception as an aid during the installation procedure – see Table 1. When the tamper switch is
closed, the bi-color LED provides indication regarding power status – see Table 2.
LED Indication Description
Flashing Green Signal Reception
Flashing Red Signal Transmission
Table 1: LED Indication (Tamper Open)
LED Indication Description
Steady Green AC & Battery OK
Flashing Red AC Loss
Flashing Orange Low Battery
Table 2: LED Indication (Tamper Closed)
Registering the Repeater to the Control Panel
For the control panel to recognize the repeater, you must register the repeater to the control panel.
To register the repeater to the control panel:
1. Set the control panel to Registration mode as follows:
• From the Programming menu, select Devices, Repeaters [914].
• Select the repeater you want to register (1-4).
• From the repeater’s sub-menu, select Register [#1].
2. Send two Status transmissions from the repeater as follows:
• On the programming keypad, press until 5. STS Transmit appears on the display.
• Press .
• Press again.
3. Confirm registration to the control panel as follows:
• When Save? appears on the control panel’s LCD display, press .
Figure 3: LCD
Programming Keypad
Loading...