Page 1
Quick User Guide
Page 2
Thank you for choosing Prime wireless intruder control panel. This quick start
guide describes the main user operating actions of the Prime. To view the full
version of the user manual, please refer our website www.electronics-line.com
.
Full Arm
Partial Arm
Perimeter Arm
Disarm Enter your user code Also silences the
Panic alarm
Fire alarm
Medical alarm
Check system troubles
Global Chime
Press
Press
Press
Press and hold down +
Press and hold down
Press and hold down
Press
Press
+
+
and scroll the list
If required, enter
your user code
siren in the event
of an alarm
Also silences any
trouble tones
Access Menu Mode
Service Call
Turn On / Off PGM
Press
Press and hold
/ 30
then [User Code]
2
Page 3
LEDs Indication
Red LED:
Off: System disarmed
On : System armed
Flashing: Alarm
Green LED:
On: Power OK
Off: No power
Flashing: (Slow) Low battery –
main or detector, (Fast) AC loss
Edit/Delete User Code
1. Go to the main display press .
2. Enter master code (Default code 1234)
3. Select [4] User Code and press
Bypass / Unbypass a zone
1. Go to the main display press .
2. Enter master code (Default code 1234)
3. On the Main menu, press [21]
SMS Control Commands
Controlling the System through SMS
Command Code Numbers:
120: Disarm
121: Full arm
122: Part arm
123: Perimeter arm
124: Full + Perimeter Arm
4. Select a user and press
5. Select [1] Edit Code.
6. Edit the user code or enter 0000 to delete
7. Press
.
4. Select a zone and press
5. To save the status, press
then .
125: Part + Perimeter Arm
0XX: HA unit XX off
1XX: HA unit XX on
030: PGM off
130:PGM on
200: System arm status
SMS Structure: [Free text - Up to 43 characters][#][User Code][Command]
to toggle
and
Example: DISARM#1234120
Example to activate HA unit: Boiler On#1234108
SMS Command Descriptor
B o i l e r O n # 1 2 3 4 1 0 8
3
User Code On Unit
Page 4
Telephone Control Commands
1. Dial the number of the premises
If your system is connected to a regular phone line. Dial the number of the
panel and wait for three rings then hang up. Wait at least five seconds and dial
the number again. On the second ring the control system answers and sounds
two tones.
If your system support cellular communication dial and wait until the system
answers and two tones are heard.
2. Within 15 seconds, enter the Telecontrol Code (code 29). After a tone sounds, press:
2: 2 Way Audio
3: Full arm
4XX: Activate Home Automation unit
5XX: Deactivate Home Automation Unit
430: PGM on
530: PGM off
6: Disarm
7: Extend the call
9: Cancel siren
*#: Disconnect the line
Keyfob
: Full Arm
: Disarm
: Part Arm, Home Automation
/ : Perimeter Arm, Home Automation
Electronics Line 3000 Ltd. 01/2012 5IN1510
Loading...