Electrolux Z7040 User Manual

NOTE: Please check to see if the

corona wire assembly has
been dislodged during
shipping. The shipping tape
does not have to be removed
to operate cleaner. Please
see page 5 and 6 for
instructions.

Electrostatic

Air Cleaner

Household Type

Model Z7040

Index

Important Safeguards ....................... 2

Operating Instructions ....................... 3

Cleaning and Maintenance ............... 4

Troubleshooting................................. 5

Corona Wire ...................................... 6

Warranty............................................ 6

Customer Order Form ....................... 7

www.electrolux.com

IMPORTANT SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed,
including the following:

READ ALL INSTRUCTIONS BEFORE USING THIS AIR CLEANER.

WARNING

To reduce the risk of fire, electric shock, or injury:

• High voltage. Turn off the power switch and unplug before servicing. This equipment

should be inspected frequently and collected dirt removed from it regularly to prevent
excessive accumulation that may result in flashover and/or risk of fire.

• Do not use outdoors or on wet surfaces.

• Do not allow to be used as a toy. Close attention is necessary when used by or near

children.

• Use only as described in this manual. Use only manufacturer’s recommended

replacement parts.

• Do not use with damaged cord or plug. If air cleaner is not working as it should, has

been dropped, damaged, left outdoors, or dropped into water, return it to a service
center before using.

• Do not pull or carry by cord, use cord as a handle, close door on cord, or pull cord

around sharp edges or corners. Keep cord away from heated surfaces.

• Do not use extension cords or outlets with inadequate current carrying capacity.

• Turn off all controls before unplugging.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Do not handle plug or air cleaner with wet hands.

• Do not put any object into openings. Do not use with any opening blocked; keep

free of dust, lint, hair, and anything that may reduce airflow.

• Do not use without filters in place.

• Store your cleaner indoors in a cool, dry area.

• Do not use in humid places such as bathrooms. If liquid enters the air cleaner, turn it

off and have it inspected by an authorized Electrolux service station.

• Do not use near flammable gases.

• Do not locate under a smoke alarm.

• Do not put objects on top of or inside the unit.

• Do not block the grills.

SAVE THESE INSTRUCTIONS

GENERAL INFORMATION

To reduce the risk of electric shock, this appliance has a polarized plug (one blade

is wider than the other). This plug will fit in a polarized outlet only one way. If the plug
does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a
qualified electrician to install the proper outlet. Do not change the plug in any way.

BEFORE YOU PLUG IN YOUR AIR CLEANER, check the voltage rating plate located
on the back of the unit to check if it agrees within 10% of the voltage available. (See
Rating Plate).

DO NOT OIL the motor at any time. The bearings are permanently lubricated
and sealed.

2

GENERAL INFORMATION (continued)

Rating Plate

The model, type, and serial number are
indicated on the rating plate located on the
back of the cleaner. For prompt and complete
service information, always refer to these
numbers when inquiring about service.

Model & Type______________________Serial No._________________________

MODEL TYPE SERIAL NO.

VOLTS AMPS. HERTZ

SERVICE INFORMATION: USA1-800-282-2886

Canada 1-800-282-2886

OPERATING INSTRUCTIONS

5

4

3

1

2

7

8

11

910

C

1. Air outlet grills

2. Reset button for filter replacement

3. Audio Sensor

4. Display

5. Fan Speed Control

6. Air inlet grills

CONTROLS

6

7. Pre-filter Door

8. Carrying Handle

9. Power Cord

10. Compartment for unused cord

11. Top cover release button (On both
sides of air cleaner.)

Automatic Mode A This position adjusts the fan

speed to the noise level in the room.This automatic

B
mode senses room noise to increase or decrease
fan speed. This mode is a good choice when

A
entertaining.

Automatic Mode B This position adjusts the fan

speed to the degree of air contamination in the room.

Manual Mode C This position provides a manual

setting for the fan speed. O is off, 3 is highest speed.

USAGE

All models are designed to run continuously with the fan speed set to (1). When required,
they can be run at higher speeds (2) and (3).

The best results are achieved by leaving the air cleaner on around the clock. (it uses
less power than most light bulbs).

3