Electrolux JLBIHD906 User Manual
JLBIHD906
built-in cooker hood
Instruction manual
Important Safety Information
It is most important that this instruction manual should be retained with the appliance for future
reference. Should the appliance be sold or transferred to another owner, or should you move house and
leave the appliance, always ensure that the book is supplied with the appliance in order that the new
owner can get to know the functioning of the appliance and the relevant warnings. These warnings ha
ve been pr ovided in the inter est of saf ety . You MUST read them carefully before use or installation by a qualified person. If you are unsure of the meanings of these warnings contact the John Lewis
branch from which you purchased the appliance.
Installation
• Any installation work must be undertaken by a qualified and
competent person to the relevant National Standards.
• This hood must be installed in accordance with the installation instructions and all measurements must be adhered
to.
• If the cooker hood is installed for use above a gas appliance
then the provision for ventilation must be in accordance
with the Gas Safety Codes of Practice BS.6172, BS.5440
and BS.6891 (Natural Gas) and BS.5482 (LP Gas) 1994,
the Gas Safety (Installation & Use) Regulations, the Building
Regulations issued by the Department of the Environment,
the Building standards (Scotland) (Consolidated) Regulations issued by the Scottish Development Department.
• The fan motor of this cooker hood incorporates a cut-out
device which will operate if the cooker hood is installed
below the minimum height recommended under section
‘Clearance Height’, or if the motor becomes overheated.
If the cut-out device is activated, switch off the fan motor
and allow the cooker hood to cool. The cut-out device will
reset itself when the fan motor has cooled significantly.
• It is dangerous to alter the specifications or modify this
product in any way.
• When installed between adjoining wall cabinets the wall
cabinets must not overhang the hob.
• If the room where the hood is to be used contains a fuel
burning appliance such as a central heating boiler then its
flue must be of the room sealed or balanced flue type.
• If other types of flue or appliances are fitted ensure that
there is an adequate supply of air to the room.
• Hoods can be used safely with appliances connected
to a chimney if the room and/ or flat (air/environment
combination) is ventilated from outside using a suitable
ventilation hole approximately 500-600cm² large to avoid
the possibility of a depression being created during operation of the hood
• The ducting system for this appliance must not be connected to any existing ventilation system which is being
used for any other purpose.
• Do not install above a cooker with a high level grill.
Child Safety
• This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls
or play with the appliance.
Use
• This product is for domestic use only.
• Never leave frying pans unattended during use as overheated fats and oils might catch fire.
• Never do flambé cooking under this cooker hood.
• Do not leave naked flames under the hood.
• This cooker hood is designed to extract unpleasant odours
from the kitchen, it will not extract steam.
Maintenance and Cleaning
• This appliance can be a hazard if the synthetic paper and
charcoal filters are not replaced as recommended.
Service
• Under no circumstances should you attempt to repair the
appliance yourself. Repairs carried out by inexperienced
persons may cause injury or more serious malfunction.
Refer to your local Service Force Centre. Always insist
on genuine spare parts.
Environmental Information
• After installation please dispose of the packaging with due
regard to safety and the environment.
• The symbol
indicates that this product should not be treated
as normal household waste. Instead it shall be handed over
to an approved collection facility for the recycling
of electrical and electronic equipment. By ensuring
this product is disposed of correctly, you will help prevent
potential negative consequences for the environment and
human health, which could otherwise be caused by
inappropriate waste handling of this product. For more
detailed information about recycling of this product, please
contact your local city office, your household waste
disposal service or the shop where you purchased the
product.
on the product or on its packaging
2
Contents
For the User
Important Safety Information 2
Description of the Appliance 4
Using the cooker hood 10
Cooker Hood Controls 10
To Operate 10
Recirculation 10
Extraction 10
Maintenance and Cleaning 12
External Cleaning 12
Cleaning the Comfort panels 12
Metal Grease Filters 12
Charcoal Filters 13
To Remove/Replace Charcoal Filter 14
Changing the Halogen Spot Lamp 14
Something Not Working 15
Repairs and After Sales Service 15
For the Installer
Electrical Connections 9
Electrical Requirements 9
Electrical Connection 9
Installing the Cooker Hood 5
Installation Requirements 5
Unpacking 5
Drilling the Ceiling/Support Shelf 6
Fixing the Frame 6
Extraction 7
Recirculation 8
Fitting the Chimney Stack 8
Fitting Hood body 8
Guide to use the Instruction Manual
The following symbols will be found in the text to guide
you through the instruction book
Safety instructions
Step by step instructions
Environmental Information
This appliance complies with the followings E.E.C. Directives:
- 89/336 (Electromagnetic Compatibility Directive)
- 73/23 (Low Voltage Directive)
- 93/68 (General Directives)
and subsequent modifications
3
Description of the Appliance
4
Installation
Please ensure that when the appliance is installed it is easily accessible to an engineer in the event
of a breakdown.
All installations must comply with the local authorities requirements for the discharge of exhaust air.
Incorrect installation may affect the safety of this cooker hood.
Installation Requirements
Before installation check the wall to which the cooker hood is to be fitted for electric cables, water
pipes or gas.
The chimney hood must be installed according to the instructions suppliers below and by qualified and
competent personnel to the relevant National Standards.
This cooker hood is designed to be fixed to any horizontal surface over a cooking area, and can be used in the extraction
(ducted to the outside) or recirculation mode.
The installation work must be undertaken by a qualified and competent person.
The manufacturer disclaims any responsibility for damage due to incorrect installation of the cooker hood or if the
hood is not installed in compliance with relevant regulations controlling this type of installation.
Unpacking
Before unpacking the cooker hood position the carton
with the arrows pointing upwards as illustrated on the
carton.
The cooker hood is made up of the following compo-
nents:
Ref. Q.ty Product Components
1 1 Hood Body, complete with: Controls, Light,
2 1 Telescopic Chimney comprising:
2.1 1 Upper Section
2.2 1 Lower Section
7.1 1 Telescopic frame complete with extractor,
7.1a 1 Upper frame
7.1b 1 Lower frame
9 1 Reducer Flange ø 150-120 mm
10 1 ø120-125 Ducting flange
14 1 Recirculation extension ducting
14.1 2 Recirculation extension ducting
15 1 Recirculation spigot
24 1 Junction box
25 2 Pipe clamps
Ref. Q.ty Installation Components
12c 6 Screws 2,9 x 9,5
12e 2 Screws 2,9 x 6,5
12f 4 Screws M6 x 10
21 1 Drilling template
Q.ty Documentation
1 Instruction Manual
Blower, Filters
consisting of:
5
Loading...