Electrolux EW30SO60QS Installation Manual

MICROWAVE WALL OVEN INSTALLATION INSTRUCTIONS

to top of cp angle

(59.8 cm)

23 ½"

20 ¾"

(52.7 cm)

18"

Installation and service must be performed by a qualiﬁed installer.

IMPORTANT: Save for local electrical inspector's use.

Read and Save these instructions for future reference.

The electrical requirements for this oven are 120 volts, 15 amps.

NOTE

Base must be capable of supporting 150 pounds (68.0 1. kg) for the Microwave Wall Oven only.

Make sure base is level and front of cabinet is square. If 2. the cabinet base is not level, the oven will tend to slide out when opening the door.

Minimum required distance is 36" (91.44 cm) from the 3. ﬂo or.

The outlet should not be located in the shaded area of 4. Figure 1. It is required the outlet be a de dicated 120 volts with a 15amp rating for the appliance.

Minimum required d ist ance b etwe en the Microwave 5. Oven and the wall oven cutouts should be at least 3 inches. The actual visible space will be reduced due to the overlap of the Microwave Oven lower vent and the wall oven.

Figure 1

PRODUCT DIMENSIONS

MODEL A B C D

27" (68.8) Microwave 27" (68.8) 221/4" (56.5) 247/8" (63.2) 21

30" (76.4) Microwave 30" (76.4) 221/4" (56.5) 273/8" (69.5) 21

30" (76.4) Convection

Microwave

MODEL Min. F Max. G Min. H Max. I

27" (68.8) Microwave 251/8" (63.8) 255/8" (65.1) 24" (61.0) min. 21"(53) 211/2"(54.6) 27" (68.8) min.

30" (76.4) 22" (55.9) 28" (71.1) 21

CUTOUT DIMENSIONS AND CABINET WIDTH

/16" (55.1)

30" (76.4) Microwave 275/8" (70.2) 281/8" (71.4) 24" (61.0) min. 21"(53) 211/2"(54.6) 301/8" (76.5) min.

30" (76.4) Convection

Microwave

All dimensions are in inches (cm).

281/2"(72.4) 29" (73.7) 24" (61.0) min. 21"(53) 211/2"(54.6) 301/8" (76.5) min.

TINSEB504MRR0

MICROWAVE WALL OVEN INSTALLATION INSTRUCTIONS

Safety

Door Latch

Hinge

Oven Cavity

Waveguide Cover

Door Seals

and Sealing

Surfaces

IMPORTANT NOTES TO THE INSTALLER

Read all instructions contained in these installation 1. instructions before installing the Microwave Wall Oven. This oven can be built into a cabinet or wall by itself or above any electric wall oven or warming drawer.

Remove all packing material from inside the oven cavity 2. before connecting the electrical supply to the Microwave Wall Oven. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the cavity ceiling. See Figure 2A.

IMPORTANT SAFETY INSTRUCTIONS

Never use your appliance for warming or heating the room. Prolonged use of the oven without adequate

ventilation can be dangerous.

Carpentry

Refer to Figure 1 for the dimensions required for your appliance, and the space necessary to install the oven. The oven support surface should be solid plywood or similar material, the surface must be level from side to side and from front to rear.

Electrical Requirements

The appliance operates on a 120 volt, 60 Hz electrical supply with a separate ground wire. Provide a separate circuit with a fuse or circuit breaker rated for 15 amps.

Observe all governing codes and local ordinances

IMPORTANT NOTE TO THE CONSUMER

Keep these instructions with your Owner's Guide for future reference.

Figure 2A Figure 2B

Remove the 2 shipping duct supports (see Figure 2B) by 3. removing the 2 screws securing each side. Reinsert 2 screws (each side) to secure the stainless cover.

Remove the feature sticker, if there is one, from the 4. outside of the door.

Check the oven for any damage, such as misaligned or 5. bent door, damaged door seals and sealling surfaces, broken or loose door hinges and latches and dent inside the cavity or on the door.

If there is any damage, DO NOT operate the oven and contact your dealer or ELECTROLUX AUTHORIZED SERVICER.

Observe all governing codes and local ordinances.6.

Be sure to leave these instructions with the consumer.7.

To prevent damage to the oven control, during cold te mpera ture w eathe r, w ait at l east th ree (3) hour s af ter receiving this oven be fore supplyin g power to the appliance. This will prevent possible damage to the built-in oven control at power on.

Cabinet Installation

The Microwave Wall Oven can tip when the door is open. The Anti-Tip brackets supplied with the Mi crow ave Wal l Oven mu s t be a t t ached to th e cabinet and the appliance to prevent t ipping of the unit and injury to persons.

ANTI-TIP BRACKETS INSTALLATION INSTRUCTIONS

Unpack the Microwave Wall Oven and find the 2 1. Anti-Tip brackets and screws included in the literature package.

Install the Anti-Tip bracket in the cabinet as shown 2. on Figure 3. Note: To prevent damage to cabinet, it is recommended to drill ¹/16" (0.16 cm) diameter pilot holes before installing the Anti-Tip brackets.

+ 2 hidden pages