Electrolux EI23CS35KB0, EI23CS35KB1, EI23CS35KB2, EI23CS35KS0, EI23CS35KS1 Installation Guide

...

Installation Instructions for Side-By-Side Refrigerator This document should only be removed by customer after installation.

Tools Necessary:

reTheinstallationSite

Your refrigerator is designedto be part of a built-in kitchen cabinet system. Be sureto coordinate site preparation and

installation with your kitchen contractor. Includethese minimum guidelines in your site preparation:

* Choosea placenearagrounded electrical outlet.

Donot use anextensioncord or an adapter plug.

Avoid direct sunlight and close proximity to a range, dishwasher or other heat source.

Floorshould be level andableto support afully loaded refrigerator.

The refrigerator's Ice& Water Dispenserrequires water supply access.

Planfor easyaccessto counter tops when removingfood.

* Forcomplete accessto drawers and freezer baskets

doors must be ab eto fu y open.

Allow the following clearancesfor easeof installation proper air c rcu at on,and p umb ngand e ectr ca connect ons: Sides & Top.3/8 inch

Rear. 1inch

Trans oft Un acka ed Refri orator ToSite

By now,you have already removed your refrigerator's shipping carton. You may

sti,II needto use a hand truck to move it through close spaces or entrances. If the

refrigerator is larger than an entrance, consiaer two options:

Removethe entrancedoor if one exists. Removethe refrigeratordoors (see howinyour Use& CareGuide).

When using a hand truck:

* Loadrefrigerator from sideof cabinet only.

Donot run retainingstraps over handles. Donot overtighten retaining straps. Neveruserefrigeratorhandlestomove the refrigerator.

Removetapefrom doors only after unit is in place.

ConnectWaterSupply

Before Installing The Water Supply Line, You Will Need:

* BasicTools: adjustable wrench, flat-blade screwdriver,

and PhillipsTM screwdriver Access to a household cold water line with water

pressure between30 and 100 psi.

A water supply line made of 1Ainch (6 mm) OD,copper

or stainless steel tubing. To determine the length of

tubing needed,measure the distance from the ice maker

inletvalve atthe back of

the refrigerator to your cold water pipe. Then add approximately 7 feet (2.1

meters), so the refrigerator

can be moved outfor cleaning (asshown).

A shutoff valve to connect the water supply lineto your

household water system. DO NOTuse a self-piercing type

shutoff valve. A compression nut

and ferrule (sleeve) for connecting a copper water supply line to the ice maker

inletvalve.

ToConnectWaterSupplyLine ToIce Maker Inlet Valve

1. Disconnectrefrigeratorfrom electricpowersource. _ _ ....

TurnONwatersupplyandflush supplylineuntil .......... t_,i

2. Placeendofwatersupplylineinto sinkor bucket. _,ff_,_;;2:p,o _','_'_

waterisclear.TurnOFFwatersupplyat shutoff \_ _""

valve. _ _ili_'d:_

3. Removeplasticcapfromwatervalveinletand Pp::

discardcap. _ ........

4. Ifyou usecoppertubing- Slidebrasscompression __"_ii ....

nut,then ferrule (sleeve)onto watersupplyline. i _ '_'_'"_

Pushwatersupplyline intowatervalveinletas far ...........

asit will g° (1AInch/64 mm) Slideferrule (sleeve)_iii

intovalveinlet andfingertightencompresstonnut ...............

ontovalve.Tightenanotherhalfturn with awrench; _ "_!_

DONOToverttghten.SeeFigure1.......................................

RemoveInternal Shi in Materials

Electrolux uses packing foam and tape to secure the internal parts of your refrigerator for shipping. Once the refrigerator is in position, you can remove this material.

1 FOAM BLOCK-- --SHELF SPACER WiTH TOE GRKL

1 PIECE OF TAPE--

3 PIECES OF TAPE-- _

3 PIECES OF TAPE--

2 PIECES OF TAPE_

5 PIECES OF TAPE-- 2 PIECES OF TAPE_

4 HECES OF TAPE--

2 PIECES OF TAPE _ ...........................

Location ofthese materials may vary depending on your model,

L4PI_OESOF_APE

-- .CESOF A

_ A.oOA,R_OOMPA_ME.T

_ _ _ 12 PIECES OFTAPE

&___--_P,EOESOF_APE

_ -_ FOAM_OOKS

...._........................................_ _ ! _e P,EOESOF_APE

-- BO OPOOORB,.S

Problems?Tr TheseSu estions

Operation problems are possible if any of the installation tasks are not completed. Hereis a list of things to check for:

Is the refrigerator's power cord plugged in? Is the refrigerator connected to the household water supply? Ifyou had to remove the refrigerator and freezer doors, did you reattachwater and power connectors

at the door hinges? (Seethe Use& CareGuidefor detailed instructions on removing and replacing doors.)

Is the ice maker power switch turned On?

Other possibilities to check:

Is the power to the receptacleturned on? Is the water filter above the fresh food compartment fully seated (see Use& CareGuidefor details)?

Ifyou still haveoperation problems after checking thesesuggestions, please seethe "Solutions To

Common Problems" section in your Use & Care Guide.

What's Next?

Congratulations. You are ready to beginenjoying your newElectrolux refrigerator.

To becomeaware of important safety instructions and learn how to operate your refrigerator, please

readthe entire Use & CareGuide.

You may want to start with the "Normal Operating Sights & Sounds" section of the Guideto learn more about what to expect during typical operation.

Pleaseregister your product. Youcan register onlineat www.electroluxusa.com, or you can simply

send in the Registration Card.

AndthankyouforchoosingElectro/ux.

Installation Checkoff List

Doors ice Maker

E]Handlesare secure and tight E]Door seals completely to cabinet on all sides E]Freezerdoor is level across the top

Leveling

E]Refrigerator is level,side to side and tilted

1/4inch (6 mm) front to back E]Toegrille is properly attached to refrigerator E]Cabinetis setting solid on all corners

Electrical Power

E]Housepower turned on E]Refrigerator plugged in

E]House water supply connected to

refrigerator

E]No water leaks present at all connections -

recheck in 24 hours E]lce Maker is turned ON E]lce & WaterDispenser operates correctly E]Front filter must beflush with filter housing

(some models)

FinalChecks

E]Shipping material removed E]Fresh Foodand Freezertemperatures set

E]Crisper Humidity controls set E]Registration Card sent in

Not satisfied with the installation of your refrigerator? L>Please contact the store where you purchased it.

P/N:241868803