Gas hobs
INSTRUCTION BOOKLET
Please read this instruction booklet before using the appliance
Mod. EHG 770
35675-7402 |
|
GB |
|
|
|
Important Safety Information
You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 950950
Installation
λThis hob must be installed by qualified personnel, according to the manufacturer’s instructions and to the relevant British Standards.
λAny gas installation must be carried out by a registered CORGI installer.
λRemove all packaging before using the hob.
λEnsure that the gas and electrical supply complies with the type stated on the rating plate, located near the gas supply pipe.
λDo not attempt to modify the hob in any way.
Service
λThis hob should only be repaired or serviced by an authorised Service Engineer and only genuine approved spare parts should be used.
Environmental Information
λAfter installation, please dispose of the packaging with due regard to safety and the environment.
λWhen disposing of an old appliance, make it unusable, by cutting off the cable.
Child Safety
λThis hob is designed to be operated by adults. Do not allow children to play near or with the hob.
λThe hob gets hot when it is in use.
λChildren should be kept away until it has cooled.
λChildren can also injure themselves by pulling pans or pots off the hob.
During Use
λThis hob is intended for domestic cooking only. It is not designed for commercial or industrial purposes.
λWhen in use a gas cooking appliance will produce heat and moisture in the room in which it has been installed. Ensure there is a continuous air supply, keeping air vents in good condition or installing a cooker hood with a venting hose.
λWhen using the hob for a long period time, the ventilation should be improved, by opening a window or increasing the extractor speed.
λDo not use this hob if it is in contact with water. Do not operate the hob with wet hands.
λEnsure the control knobs are in the ‘OFF’ position when not in use.
λWhen using other electrical appliances, ensure the cable does not come into contact with the hot surfaces of the cooking appliance.
λUnstable or misshapen pans should not be used on the hob as unstable pans can cause an accident by tipping or spillage.
λNever leave the hob unattended when cooking with oil and fats.
λNever use plastic or aluminium foil dishes on the hob.
λPerishable food, plastic items and areosols may be affected by heat and should not be stored above or below the hob unit.
Keep this instruction book for future reference and ensure it is passed on to any new owner.
Guide to Use the instructions
The following symbols will be found in the text to guide you throughout the Instructions:
Safety Instructions
ΦStep by step instructions for an operation
Hints and Tips
Environmental Information
This appliance complies with the following
E.E.C. Directives:
*73/23 - 90/683
(Low VoltageDirective);
*93/68 (General Directives);
*89/336 (Electromagnetical Compatibility Directive);
*90/396 (Gas Appliances), and subsequent modifications
2
Contents
For the User |
|
For the Installer |
|
Important Safety Information |
2 |
Instructions for the Installer |
8 |
Description of the Hob |
3 |
Important safety requirements |
9 |
Operation |
4 |
Installation |
9 |
Maintenance and Cleaning |
4 |
Building In |
10 |
Something Not Working? |
5 |
Electrical connections |
11 |
Service and Sparte Parts |
6 |
Wiring Diagram |
12 |
Customer Care Department |
6 |
Fault Finding |
12 |
Guarantee Conditions |
7 |
Commissioning |
14 |
|
|
Conversion from Natural Gas to LPG |
15 |
Description of the Hob
2
1 3
4
2
5
6
1.Auxiliary Burner
2.Semi-rapid Burners
3.Ultra-rapid Triple-crown Burner
4.Rapid Burner
5.Ignition push-button
6.Control knobs
3
Operation
Hob burners
ΦTo light a burner:
λ push the electric ignition push-button which is marked by a little spark symbol (
);
λ at the same time turn the relevant control knob anticlockwise to maximum position;
λ then adjust the flame as required.
If the burner does not ignite, turn the control knob to zero, and try again.
To ensure maximum burner efficiency, you should only use pots and pans with a flat bottom fitting the size of the burner used (see table).
If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the
handle to overheat.
As soon as a liquid starts boiling, turn down the flame so that it will barely keep the liquid simmering.
Take care when frying food in hot oil or fat, as the overheated splashes could easily
ignite.
If the control knobs become difficult to turn, please contact your local Electrolux Service Force Centre.
Using the Wok Stand
A wok stand is provided to enable you to use a round bottomed wok on the hob. The wok stand must only be used on the central burner, and should not be used with any other type of wok or pan.
When fitting the wok stand, ensure the recesses in the frame fit securely onto the bars of the pan supports, as shown in the diagram.
Burner |
minimum |
maximum |
|
|
|
|
diameter |
diameter |
|
|
|
|
|
|
Ultra-rapid |
|
|
|
|
(Triple-crown) |
180 mm. |
260 mm. |
|
|
Large (rapid) |
180 mm. |
260 mm. |
|
|
Medium (semi-rapid) |
120 mm. |
220 mm. |
|
|
Small (Auxiliary) |
80 mm. |
160 mm. |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Maintenance and Cleaning
Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the
electricity supply.
The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool.
The Hob Top
Regularly wipe over the hob top using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following:
-household detergent and bleaches;
-impregnated pads unsuitable for non-stick saucepans;
-steel wool pads;
-bath/sink stain removers.
Should the hob top become heavily soiled, it is recommended that a cleaning product such as Hob Brite or Bar Keepers Friend is used.
4
Pan Supports and Wok Stand
To keep the pan supports in the correct position, they are hooked into hinges at the back of the hob.
The pan supports can be lifted for easier cleaning, as shown in Fig. 1.
To remove the pan supports completely, proceed as shown in Fig. 2.
The pan supports and the Wok Stand are dishwasher proof. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessay, remove stubborn stains using a paste cleaner.
The Burners
Theburnercapsandcrownscanberemovedforcleaning. Wash the burner caps and crowns using hot soapy water, and remove marks with a mild paste cleaner. A well moistened soap impregnated steel wool pad can be used with caution, if the marks are particularly difficult to remove.
After cleaning, be sure to wipe dry with a soft cloth.
FO 2030
Fig. 1
FO 2238
Fig. 2
Something Not Working?
If the hob is not working correctly, please carry out the following checks before contacting your local Electrolux Service Force Centre.
SYMPTOM |
SOLUTION |
|
ν There is no spark when lighting the gas |
υ Check that the unit is plugged in and the electrical |
|
|
supply is switched on |
|
|
υ Check that the RCCB has not tripped (if fitted) |
|
|
υ Check the mains fuse has not blown |
|
|
υ Check the burner cap and crown have been |
|
|
replaced correctly, e.g. after cleaning. |
|
|
|
|
ν The gas ring burns unevenly |
υ Check the main jet is not blocked and the burner |
|
crown is clear of food particles. |
||
|
||
|
υ Check the burner cap and crown have been |
|
|
replaced correctly, e.g. after cleaning. |
|
|
|
If after all these checks, your hob still does not operate correctly, contact your local Electrolux Service Force Centre.
Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls.
In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
5
Service and Spare Parts
In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Electrolux Service Force Centre by telephoning:
0870 5 929929
Your telephone call will be automatically routed to the Service Force Centre covering your post code area. For the address of your local Service Force Centre and further information about Service Force, please visit the website at www.serviceforce.co.uk
Before calling out an engineer, please ensure you have read the details under the heading “Something Not Working.”
When you contact the Service Force Centre you will need to give the following details:
1.Your name, address and post code
2.Your telephone number
3.Clear and concise details of the fault
4.The model and serial number of the appliance (found on the rating plate)
5.The purchase date
Customer Care Department
For general enquiries concerning your Electrolux appliance or for further information on Electrolux products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www.electrolux.co.uk
Customer Care Department
ELECTROLUX
55-77 High Street
Slough
Berkshire
SL1 1DZ
Tel. 08705 950950 (*)
* calls to this number may be recorded for training purposes.
6
Loading...