ElectrIQ PLAC12000HP User Manual

Page 1 of 18

Platinum Range

PLAC12000HP

PORTABLE AIR CONDITIONER WITH HEAT PUMP

USER MANUAL

Thank you for choosing ElectrIQ.

Please read this user manual before using this innovative Air Conditioner and

keep it safe for future reference.

Visit our page www.electrIQ.co.uk for our entire range of Intelligent Electricals

HIGH

MID

LOW

HEAT

DRY

FAN

COLL

TIMER

SLEEP

SWING

Page 2 of 18

CONTENTS

1．．．．SAFETY INSTRUCTIONS …………………………………….. 3

2．．．．FEATURES AND PARTS LIST ………………………….. 4

3. ACCESSORIES ……………………………………….….... 6

4．．．．INSTALLATION ………………………………….……………. 7

5．．．．VENTING ………..………………………………….……………. 8

4．．．．OPERATION AND SETTINGS ……………………………. 9

5．．．．WATER-DRAINAGE …………………………………………. 14

6．．．．MAINTENANCE ……………………………………………… 15

7．．．．TROUBLE SHOOTING ………………………………….. 16

8．．．．APPENDIX ……………………………………………………. 17

Page 3 of 18

SAFETY INSTRUCTIONS

Important!

• Carefully read the instructions before operating the unit

• This appliance is for indoor use only.

• Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.

• Installation must be in accordance with regulations of the country where the unit is used.

• If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified

by a qualified electrician.

• This air conditioner has been tested and is safe to use. However, as with any electrical appliances - use it with

care.

• Disconnect the power plug from socket before dismantling, assembling or cleaning.

• Avoid touching any moving parts of the appliance.

• Never insert fingers, pencils or any other objects though the guard

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities. It is also not intended for use by those with a lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• Do not leave children unsupervised with this appliance.

• Do not clean the unit by spraying it or immersing it in water.

• Never connect the unit to an electrical outlet using an extension cord. If an outlet is not available, one should be

installed by a qualified electrician.

• Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not stretched or exposed to

sharp object/edges.

• A damaged supply cord should be replaced by the manufacturer or a qualified electrician in order to avoid a

hazard.

• Any service other than regular cleaning or filter replacement should be performed by an authorized service

representative. Failure to comply could result in a voided warranty.

• Do not use the appliance for any other purposes than its intended use.

• The air conditioner unit must always be stored and transported upright, otherwise irreparable damage may be

caused to the compressor; if in doubt we suggest waiting at least 24 hours before starting the unit.

• Avoid restarting the air conditioning unit unless 5 minutes have passed since being turned off. This prevents

damage to the compressor.

• Never use the mains plug as a switch to start and turn off the air conditioning unit. Use the provided ON/OFF

switch located on the control panel.

• Always place the unit on a dry and stable surface.

• The appliance should not be installed in laundry or wet rooms

Energy Saving and Unit Safety Protection Tips

• Do not cover or restrict the airflow from the outlet or inlet grills.

• For maximum performance the minimum distance from a wall or objects should be 50cm.

• Keep the filters clean. Under normal conditions, filters should only need cleaning once every three weeks

(approximately). Since the filters remove airborne particles, more frequent cleaning maybe necessary, depending on
the air quality.

• For the initial startup set the fan speed to maximum and the thermostat to 4-5 degrees lower than the current

temperature. After, set the fan switch to low and set the thermostat to your desired setting.

• To protect the unit we recommend not using the cooling function when the ambient temperature is higher than

35℃.

• To protect the unit we recommend not using the heating function when the ambient temperature is lower than

7℃. Use electrical or alternative heating to raise the room temperature to 10°C than start the air conditioner in heat
mode and set it to the desired temperature. Heating by heat pump will take longer but is cheaper than any other form
of heating and ideal for maintaining room temperature constant.

Page 4 of 18

FEATURES AND PARTS LIST

Features

 Designer inspired luxury model

 Louvres outlet closes automatically when shutting down the unit, this prevents dust and dirt

entering the machine.

 Bright LED screen, indicates temperature and operation mode

 LCD Remote control with temperature function and follow me function

 On/Off timer function – allows you to choose when the unit operates.

 3 speed fan for best balance between maximum air flow and quitter operation



Self-evaporative system - no external water tank needed



Compressor protection technology

Page 5 of 18

Parts list：

：：

：

Front view

1
2
3

4
5 6

7

Rear view

8

10 9

11
12 13
14
15 16
17
18

1. Air outlet grille (cold/hot) 10. Recessed handle

2. Control panel 11. Drain port

3. IR receiver 12. Air outlet (hot/cold)

4. Recessed handles 13. Lower air inlet filter frame

5. Front Panel 14. Drain (heat pump model only)

6. Air outlet 15. Power cord outlet

7. Remote control 16. Lower filter mesh (behind frame)

8. Upper inlet filter frame 17. Lower tray drain outlet

9. Upper filter mesh (behind frame) 18. Castors

Page 6 of 18

Accessories:

Parts

Description

Quantity

Exhaust hose sash window adaptor type
A (oval)
or
type B (round)
With window sider kit and bolt

1 set

Wall exhaust adapter

1 piece

Round adapter

1 piece

Nut and bolt

1 set

Remote control

1 piece

Drain pipe (not supplied with all models)
can use standard hose instead

1 piece