ElectrIQ P15HP User Manual

Page 1 of 15
P15HP
PORTABLE AIR CONDITIONER WITH HEATPUMP
USER MANUAL
Thank you for choosing ElectriQ
Please read this user manual before using this innovative Air Conditioner and keep it safe for
future reference.
Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals
Page 2 of 15
CONTENTS
1SAFETY INSTRUCTIONS ………………………………………………… 3
2FEATURES AND PARTS LIST ………………………….................. 4
3INSTALLATION ………………………………….…………………….….. 6
4OPERATION AND SETTINGS ………………………………………. 10
5WATER-DRAINAGE ………………………………………………….……. 12
6MAINTENANCE …………………………………………………………….. 13
7TROUBLE SHOOTING ………………………………………………….. 14
8APPENDIX …………………………………………………………………….. 16
Page 3 of 15
SAFETY INSTRUCTIONS
Important!
Carefully read the instructions before operating the unit This appliance is for indoor use only. Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet. Installation must be in accordance with regulations of the country where the unit is used. If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary,
modified by a qualified electrician.
This air conditioner has been tested and is safe to use. However, as with any electrical appliance - use it
with care.
Disconnect the power plug from socket before dismantling, assembling or cleaning. Avoid touching any moving parts within the appliance. Never insert fingers, pencils or any other objects though the guard This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.
Do not leave children unsupervised with this appliance. Do not clean the unit by spraying it or immersing it in water. Never connect the unit to an electrical outlet using an extension cord. If an outlet is not available, one
should be installed by a qualified electrician.
Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not stretched or
exposed to sharp objects/edges.
A damaged supply cord should be replaced by the manufacturer or a qualified electrician in order to
avoid a hazard.
Any service other than regular cleaning or filter replacement should be performed by an authorized
service representative. Failure to comply could result in a voided warranty.
Do not use the appliance for any other purpose than its intended use. The air conditioner unit must always be stored and transported upright, otherwise irreparable
damage may be caused to the compressor; if in doubt we suggest waiting at least 24 hours before starting the unit.
Avoid restarting the air conditioning unit unless 3 minutes have passed since being turned off. This
prevents damage to the compressor.
Never use the mains plug or an external timer as a switch to start and stop the air conditioning unit.
Use the provided ON/OFF button located on the control panel.
Always place the unit on a dry and stable surface. The appliance should not be installed in laundry or wet rooms The appliance must be placed in a room without sources of ignition (for example: open flames, an
operating gas appliance or an operating electric heater).
The appliance must be installed, used and stored in a room with an area larger than 5m². This appliance contains about 235 g of R290 refrigerant gas. R290 refrigerant gas complies with European environmental directives. Do not use the product and contact the retailer for advice, if damage has occurred to the unit which
may have compromised the refrigerant system.
Refrigerant gas may be odourless. If the appliance is installed, used or stored in an unventilated room, the room must be such as to
prevent stagnation of possible leaks of refrigerant gas as there could be a danger of fire or explosion hazard should the refrigerant come into contact with electric heaters, stoves or other sources of ignition.
The refrigerant system should not be perforated.
Page 4 of 15
Energy Saving and Unit Safety Protection Tips
Do not cover or restrict the airflow from the outlet or inlet grills. For maximum performance the air conditioner should be situated at least 50cm from the walls or other
objects.
Keep the filters clean. Under normal conditions, filters should only need cleaning once every three
weeks (approximately). Since the filters remove airborne particles, more frequent cleaning maybe necessary, depending on the air quality.
For the initial start-up set the fan speed to maximum and the thermostat to 4-5 degrees lower than the
current temperature. After, set the fan switch to low and set the thermostat to your desired setting.
To protect the unit we recommend the unit should only be used when the room temperature is
between 7°C and 35°C. If the temperature is below this use electrical heating to raise the temperature above 10⁰C before starting the unit.
FEATURES AND PARTS LIST
Features
Full climate control, cooling, heating and dehumidifier
Self-evaporative system - no external water tank needed
Powerful but compact
LED screen, indicates temperature and operation mode Enhanced design with hot air outlet positioned higher – this allows for improved performance
with the use of a short hose
24 hour programmable timer function – allows you to choose when the unit operates Thermostat range: 16-31⁰C 3 speed fan Low, Medium and High for best balance between quiet operation and maximum
airflow
Compressor protection technology
Page 5 of 15
PARTS LIST
1. Control panel 6. Hot air filter
2. Remote control sensor 7. Water Drain hole
3. Adjustable air vent 8. Hot air outlet
4. Fish tail adaptor 9. Cool air filter
5. Exhaust hose
ACCESSORIES
Loading...
+ 10 hidden pages