ElectrIQ eiQ-RBV10 User Manual

eiQ-RBV10 Robotic Vacuum Cleaner

USER MANUAL

Thank you for choosing ElectriQ

Please read this user manual before using this robotic vacuum cleaner

and keep it safe for future reference.

Visit our page www.electriQ.co.uk for our entire range of Intelligent Electricals

FEATURES

ElectriQ brings you an easy to use robot vacuum cleaner that works both on hard
floor surfaces and carpets. This is not a sweeper but a real vacuum cleaner with
powerful suction and the latest dual side brush system.
You can now enjoy your personal time while the robot will clean for you.
Slim profile at only 8.2 cm height and 31 cm diameter this time saving device will get
in hard to reach places, including under furniture where other robots or vacuum
cleaners will fail to operate.
Simple operation includes simple to follow voice prompts, single touch ON / OFF
button and adjustable cleaning timer.
Easy to use due to automated cleaning pattern, your robot benefits from an
advanced cleaning algorithm that ensure that maximum effective cleaning is
achieved with minimum iterations. There are 6 advanced programs in operation that
will advance from spot cleaning, identifying the walls, pattern cleaning, around the
wall cleaning, systematic inline cleaning and even an under bed / sofa program.
According to the set timer the programs will be intelligently combined for maximum
cleaning efficiency.
Two extra-long side brushes around the outer edges ensure that dirt is gathered even
from corners and borders. The middle suction vacuum will ensure dirt and debris are
efficiently collected.
This robot features multi-sensors including side infrared sensors that scan 180
degrees in front of the robot to avoid collision ensuring it stops before bumping into
objects. There are also four ground sensors that will stop the robot from failing of
any steps.
Great on hard floor and low and medium pile carpet will transition most of the hard
floor / carpets setups.
With carry handle and easy to empty bag less front loading rubbish container.
An easy to clean HEPA filter will improve air quality in your household during the
cleaning operation.

SAFETY INSTRUCTIONS
Important

• Carefully read the instructions before operating the unit

• This appliance is for indoor use only.

• Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.
Always check the rating label against your electrical supply.

• If you are in any doubt about the suitability of your electrical supply have it
checked and, if necessary, retested by a qualified electrician.

• This robotic vacuum cleaner been tested and is safe to use. However, as with any
electrical appliances - use it with care.

• Disconnect the power plug from unit before dismantling, assembling or cleaning.

• Do not clean the unit by spraying it or immersing it in water.

• Never operate this appliance if the cord or power supply is damaged. Ensure the
power cord is not stretched or exposed to sharp object / edges.

• Do not use the appliance if any part or any accessory is damaged or defective.

• A damaged power supply should be replaced only with original parts from the
manufacturer.

• Avoid touching any moving parts of the appliance.

• Never insert fingers, or any other objects while machine is in operation.

• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities. It is also not intended for use by
those with a lack of experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance by a person
responsible for their safety.

• Do not leave children or animals unsupervised with this appliance.

• Only use original battery or charger from manufacturer, any third party
components may damage the unit.

• Any service other than regular cleaning should be only performed by an
authorized service representative. Failure to comply could result in a voided
warranty.

• Do not use the appliance for any other purposes than its intended use.

• Do not use the appliance in places with high humidity (>80%RH)

• Do not immerse the robot in water or other liquids. If the robot is immersed in
water or other liquids by mistake, do not touch it with your hands. If the appliance is
immersed in water or other liquids, discard it. Do not use if you spilled liquids on the
floor.

• Do not use to clean printer tonner spilled on the floor as this could cause fire.

• Before using the robot cleaner, remove any fragile objects from the floor e.g.
glasses, bottles, candles, lamps. Also removes any sharp metals, needles, nails, sharp
glass pieces or any other objects that could block or damage the roobt

• Do not place any object on the top of the robotic cleaner

• Do not leave any fragile objects on the side of the tables, cabinets etc where the
robot could bump into and cause them to fall.

Unit Safety Protection and Performance Tips

• Make sure unit is assembled correctly before use

• Charge for 24 hours before operating first time. If not using the robot for a long
time please fully charge and remove the battery

• Clean robot and brushes regularly. Empty and vacuum the dust container

• If the robot become entangled, remove brushes, clean the debris and
reassemble

Parts

1. Carry

Handle

2. LED Screen

3. Control panel

4. Dustbin cover panel

5. On / Off button

6. Right brush

7. Infrared sensor

8. Right wheel

9. Right wheel panel

10. Side right vents

11. Swivel caster

12. Battery cover

13. Left brush

14. Air suction inlet

15. Left wheel panel

16. Side right vents

17. Bottom Shell

Assembly

Wall infrared sensors Power supply adapter

Installing the side brushes

Align each brush with the hexagonal hole f ac i n g down and press firmly until

it clicks into place.

H

exagonal

hole

facing

down

D

ust bin cover

Lining filter

HEPA Filter

Dust bin handle

Charg

ing port

Dust bin