ElectrIQ AIRCUBE AC9000E, P15HP User Manual

Page 1 of 13

AIRCUBE® AC9000E

PORTABLE AIR CONDITIONER WITH HEAT PUMP

USER MANUAL

Thank you for choosing ElectrIQ.

Please read this user manual before using this innovative Air Conditioner

and keep it safe for future reference.

Visit our page www.electrIQ.co.uk for our entire range of Intelligent Electricals

Page 2 of 13

CONTENTS

1．．．．SAFETY INSTRUCTIONS ………………………………….. 3

2．．．．FEATURES AND PARTS LIST ………………………….... 4

3．．．．INSTALLATION ………………………………….…………. 5

4．．．．OPERATION AND SETTINGS …………………………….. 7

5．．．．WATER-DRAINAGE …………………………………………. 8

6．．．．MAINTENANCE ……………………………………………… 9

7．．．．TROUBLE SHOOTING …………………………………….. 11

8．．．．APPENDIX ……………………………………………………. 12

Page 3 of 13

SAFETY INSTRUCTIONS

Important!

• Carefully read the instructions before operating the unit. Please retain this manual for future reference.

Note: This AC is for indoor use only.

• Rating: This unit must be only connected to a 220-240 V / 50 Hz earthed outlet.

• Installation must be in accordance with regulations of the country where the unit is used.

• If you are in any doubt about the suitability of your electrical supply have it checked and, if necessary, modified

by a qualified electrician.

• This air conditioner has been tested and is safe to use. However, as with any electrical appliances - use it with
care.

• Disconnect the power plug from socket before dismantling, assembling or cleaning.

• Avoid touching any moving parts of the appliance.

• Never insert fingers, pencils or any other objects though the guard

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental

capabilities. It is also not intended for use by those with a lack of experience and knowledge, unless they have
been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Do not leave children unsupervised with this appliance.

• Do not clean the unit by spraying it or immersing it in water.

• Never connect the unit to an electrical outlet using an extension cord. If an outlet is not available, one should be

installed by a qualified electrician.

• Never operate this appliance if the cord or plug is damaged. Ensure the power cord is not stretched or exposed
to sharp object/edges.

• A damaged supply cord should be replaced by the manufacturer or a qualified electrician in order to avoid a
hazard.

• Any service other than regular cleaning or filter replacement should be performed by an authorized service
representative. Failure to comply could result in a voided warranty.

• Do not use the appliance for any other purposes than its intended use.

• The air conditioner unit must always be stored and transported upright, otherwise irreparable damage may be

caused to the compressor; if in doubt we suggest waiting at least 24 hours before starting the unit.

• Avoid restarting the air conditioning unit unless 3 minutes have passed since being turned off. This prevents
damage to the compressor.

• Never use the mains plug as a switch to start and turn off the air conditioning unit. Use the provided ON/OFF
switch located on the control panel.

• Always place the unit on a dry and stable surface.

• The appliance should not be installed in laundry or wet rooms

Energy Saving and Unit Safety Protection Tips

• Do not cover or restrict the airflow from the outlet or inlet grills.

• For maximum performance the minimum distance from a wall or objects should be 50cm. Unit is fitted with

thermal cut off sensor that will prevent overheating

• Keep the filters clean. Under normal conditions, filters should only need cleaning once every three weeks
(approximately). Since the filters remove airborne particles, more frequent cleaning maybe necessary, depending
on the air quality.

•

To protect the unit we recommend not using the cooling function when the ambient temperature is higher than
35°C.

•

To protect the unit we recommend not using the heating function when the ambient temperature is lower than
7°C. Use electrical or alternative heating to raise the room temperature to 10°C than start the air conditioner in
heat mode and set it to the desired temperature. Heating by heat pump will take longer but is cheaper than any
other form of heating and ideal for maintaining room temperature constant.

Page 4 of 13

FEATURES AND PARTS LIST

1. Features



Part of ElectrIQ AirCube

®

range of Air Conditioning products



Cooling, Heating and Fan mode for all around the year use



Improves comfort and indoor air quality



Reduces the humidity in the air



Self-evaporative system - no external water tank needed



Compact, designer inspired model



Side vents to prevent dust and dirt entering the machine.



The hot air outlet is positioned high on the unit – this allows for improved performance with
the use of a short hose



Two Speeds fan great for selecting improved performance vs. quitter operation



Advanced Compressor protection technology



Recessed castors for improved portability

2. Parts list

：：：：

1. Control panel (control knob) 7. Bottom drain port

2. Cold air outlet 8. RC slide in slot (NA)

3. Cold air outlet hose mount 9. Hot air outlet hose mount

4. Exhaust hose connector 10. Hot air outlet

5. Exhaust hose 11. Secondary drain port

6. Hot air inlet 12. Cool air inlet and Evaporator filter