Electra Light Big Bubble Machine Manual
Big
Bubble Machine
Thank you for choosing the
l
e
k
Pay attention to all warning labels and instructions printed on the exterior of your
Please fo
llow these operation, safety and maintenance instructions to ensure
a
Unpacking & Inspectio
n
ESPECIFICATIONS
h
CAUTIONS
Setup
Pay attention to all warning labels and instructions printed on the exterior of your
d
OPERATION
e
Save these instructions
state-of-the-art machine.
instructions.
forward to exceptional performance from your Big Bubble Machine for years to come.
By
following the suggestions found in this user manual, you can loo
Big
Bubble Machine.
Prior to use, we suggest that you carefully read all of th
You now own a rugged and powerfu
For adult use only.
children.
Never aim the output at open flames.
Extended use will make all surfaces slippery.
Position output of bubbles away from persons.
Switch off from mains when refilling the liquid or cleaning the system.
Regular cleaning of the bubble wheel is required.
Do not transport with liquid. If the machine get wet, do not use until it is completely
dry.
bubble liquid may leave permanent marks on clothing.
Never leave the unit running unattended.
The bubble machine must be installed out of the reach of
long and safe life for yourBig Bubble Machine.
Power: AC
Fuse: F2A/250V (120V Model)
Dimensions (cm):
120V/60Hz (120V Model)
AC 230V/50Hz (230V Model)
T1A/250V (230V Model)
50*40*48 cm
Big
Bubble Machine
Do not overfill your bubble machine.
Keep this device dry.
Keep the bubble machine upright.
For the 110V models, use 3-prong grounded electrical outlet only.
take care to determine that the unit is installed at the rated voltage.
Turn off or unplug when not in use.
This machine is not water-proof or splash-proof.
gets inside the housing, immediately unplug the unit and contact a service
technician or your dealer before using it again.
No user serviceable parts inside.
personnel.
For indoor use only. Not designed for outdoor use.
This appliance must be earthed.
Danger of electric shock
Overfilling will cause the unit to leak.
Refer to your dealer or other qualified service
If
moisture, water, or any liqui
Prior to use
Big Bubble Machine.
Open the shipping carton and check that all equipment necessary to operate the
system has arrived intact.
following items:
1.
This user manual.
2.
Power cord and plug.
3.
A hanging bracket.
Before beginning initial setup of your Big Bubble Machine, make sure that there
is no evident damage caused by transportation.
In the event that the unit’s housing or cable is damaged, do not plug it in and do
not attempt to use it until after contacting your dealer for assistance.
Remove all packing materials from the bubble machine.
Place bubble machine on a flat surface, or .
Turn on the power switch located on the back of the bubble machine.
that the internal bubble drum and fan are activated.
In
addition to the Big Bubble Machine, you should receive t
Bubbles are now produced.
You will notic
User Manual
for the
Big Bubble Machine
Loading...