Electra T5800 Users Manual

Transmitter T-5800
Technical da ta Transmitter T-5800
Frequency range 5725MHz - 5875MHz
Range indoor´ s in connection with suitable receivers
depending on the transmission power as well as number, thickness and material of
walls (depending on the gain factor of the antenna, the r ange can be improved up to
multiple times compared to the standard range)
Range indoor´ s in connection with suitable receivers and line of sight
depending on the gain factor of the antenna, the range can be improved up to
multiple times compared to the standard range
Video input Composite colour picture signal pos 1.0 + 0.1 V
pp
Video bandwidth 30 Hz - 5 MHz
Audio bandwidth 30 Hz - 15 kHz Audio input micro input automatically controlled
Modulation mode F3F Current consumption max. 150mA Power supply DC 5.5 V - 7.5 V (optionally 2.4 V - 3 V)
Antenna omnidirektionally antenna
Dimensions without antenna 18 x 18 x 13 (with connector strip)
Weight without mains adapter 8 g Protection class IP 30
Ambient temperatures (use/ store) -10°C- +55°C / -20°C- + 60°C
Humidity non- condensing
Connectors
Video input 6 pole terminal
Audio input 6 pole terminal
DC 6 pole terminal
Allocation schedule
DC: (red / black)
Please use a stabilised mains adapter or battery with an output of 5.5 – 7.5 V DC (150 mA). The transmitter includes a reverse connect protection. However, please consider the polarity of your power supply. Red = 5.5 – 7.5 V Black = GND
Please consider:
We don’t give guarantee for damage caused by overvoltage. Please consider that all terminals must be connected properly before the device is ready to operate.
Video: (yellow / black)
Yellow = 1 Vpp on 75 Ohms Black = GND The video signal must be a standardised composite 1Vpp signal. You can transmit each kind of composite video signals.
Audio:
The transmitter is supplied with a high sensitive electret microphone. An audio input of 500 mVeff on > 10 kOhms is available on request. Because of the controlled micro amplifier the squelch circuit may operate in case of very low noise. Therefore the volume may be adjusted up and down.
Please use shielded lines to decouple the Video and Audio signals.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, cluding interference that may cause undesired operation.
IMPORTANT NOTE: Intentional or unintentional changes or modifications not expressly approved by the party responsible for compliance must not be made. Any such modifications could void the user's authority to operate the equipment.
Loading...