Elecsky PL-606 Operation Manual
- 1 -
PL-606
FM
FM
FM
FM stereo
stereo
stereo
stereo /
/
/
/ SW
SW
SW
SW /
/
/
/ MW
MW
MW
MW /
/
/
/ LW
LW
LW
LW DSP
DSP
DSP
DSP RECEIVER
RECEIVER
RECEIVER
RECEIVER
OPERATION
OPERATION
OPERATION
OPERATION MANUAL
MANUAL
MANUAL
MANUAL
- 2 -
CONTROL
CONTROL
CONTROL
CONTROL LOCATIONS
LOCATIONS
LOCATIONS
LOCATIONS
1. Power
2. Band* & ATS
3. VM & SCAN
4. VF & SCAN
5. ETM (Easy Tuning Mode)
6. Delete
7. Memory
8. Display & Lock & Snooze
9. FM ST. & AM BW
10. Alarm
11. Time
12. FM & SW Telescopic Antenna
13. FM & SW Antenna Jack
14. Earphone Jack
15. USB 5V DC-Jack
16. Multifunctional Tuning Knob
17. Stand
18. Volume Knob
19. Battery Compartment
The unit is shut down the long-wave band before out of the factory.If you want to open the long-wave band in
the off state, press MW button 10 seconds.
LCD
LCD
LCD
LCD DISPLAY
DISPLAY
DISPLAY
DISPLAY
1. Battery consumption indicator / Charging indicator
2. Sleep timer indicator
3. Alarm on/off indicator 4Key-lock indicator
5. Temperature (Temp.)
6. Signal indicators
dBu: signal strength unit
dB : Signal to Noise Ratio (S/N) unit
7. Alarm time indicator
8. SW meter band indicator
9. ETM indicator
10. Tuning speed:
" > " Slow Tuning
" >> " Fast Tuning
11. kHz: frequency unit for MW, LW & SW
MHz: frequency unit for FM
12. Digital number display (4 Digits)
With radio off: world time, alarm time, temperature
With radio on: word time, signal strength / SNR, alarm time, temperature, local time, memory address, meter band.
- 3 -
13. Preset memory address
14. Digital number display With radio off: local time
With radio on: frequency display, band display
15. Band indicator
16. FM stereo status indicator 17Rechargeable batteries indicator
HOW
HOW
HOW
HOW TO
TO
TO
TO TURN
TURN
TURN
TURN ON/OFF
ON/OFF
ON/OFF
ON/OFF THE
THE
THE
THE RADIO
RADIO
RADIO
RADIO
1. Open the battery compartment located on the back of the unit, install 2x AA alkaline batteries observing the
battery polarity diagram on the back of the radio. Close the battery door.
2. Press the [POWER] button to turn on/off the radio.
Note:
If the radio is unable to be turned on. Please check if the batteries were installed correctly, battery capacity is sufficient
or the lock function had been applied with " " displays
on screen (press & hold the [ ] button to unlock.)
TUNE
TUNE
TUNE
TUNE IN
IN
IN
IN STATIONS
STATIONS
STATIONS
STATIONS
Press the [POWER] button to turn on your radio, then select your desired band by pressing the [FM], [MW] SW[ ] or
[ ] button. In case of receiving FM/SW broadcasting, fully extend the telescopic antenna for a better reception.
When receiving MW(LW) broadcasting, please rotate the radio or change it's location to
achieve optimum reception. You can rotate the [VOLUME] knob to adjust to appropriate
volume from 0 to 30 levels.
Now, you can turn into your favorite stations with any of the below tuning methods:
METHOD
METHOD
METHOD
METHOD 1:
1:
1:
1: ETM
ETM
ETM
ETM (EASY
(EASY
(EASY
(EASY TUNING
TUNING
TUNING
TUNING MODE)
MODE)
MODE)
MODE)
ETM is the unique tuning method designed by Tecsun. It skillfully combines the reception
circuitry & control procedure to pre-select the suspected radio station and temporarily auto stores them into the ETM
memory (not the regular 550 memories). This highly enhances the efficiency when tuning into radio stations.
Employing ETM to tune preferred
frequencies. you can easily tune into your desired stations from those preferred frequencies.
1. Press the [ETM] button with [ETM] shows on screen to enter Easy Tuning Mode.
Loading...