Elecraft XV-432 User Manual

XV432 ASSEMBLY MANUAL ERRATA

Rev. D-3, November 27, 2013

MAKE THESE CORRECTIONS TO YOUR

MANUAL BEFORE YOU BEGIN ASSEMBLY.

1. Page 12, Parts Inventory, U7: Change part number to "RA30H4047M1". This is now a metal shielded unit.

2. Page 13, Parts Inventory, R13: The value may be either 25 or 50 ohms.

2. Page 15, Parts Inventory, First Item (FL1, FL2): Add note: “These filters are supplied pre-mounted on the
XV432 RF printed circuit board.”

3. Page 28, Right Column, 7th step to end and Page 29, Left Column, first 3 steps: Because FL1 and FL2 are

already installed, relay K7 cannot be held in place using a book as described. Install K7 by holding it in place
with one finger while “tacking” it in place with a drop of solder on your iron on a pin at each end. After
confirming that it is flat against the pc board, solder the remaining pins, then go back and re-solder the first two
pins as necessary.

4. Page 29, Left Column, first step, delete duplicate sentence: “Solder just two diagonally opposite corner pins
on each relay.”

5. Page 30, Left Column, second step: The value of R13 may be either 25 ohms or 50 ohms.

6. Page 32, Right Column: Delete the last three steps. These filters are pre-mounted on the RF pc board.

7. Page 40, Figure 39: The RF Power Module part is now marked "RA30H4047M1".

Page 1 of 1