ELECOM M-IR05DR User Manual

M-IR05DR

Wireless

Optical Mouse

User's Guide

Introduction

Congratulations on your purchase of the most innovative wireless mouse. With an
incredible sensitivity to surface details and high tracking speed than other mice, the mouse
can track reliably even on tricky polished or wood-grain surfaces. It offers even more
advance that will make you more productive and more comfortable.

Features

2.4GHz (distance 6~8m), 34 Channels/224 ID

Using state-of-art technology. High tracking speed and sensitivity.

Nano receiver.

Longer battery life.

Auto-Link, Plug and Play! No need to set the channel ID.

Power on/off switch.

Ergonomic design.

800/1600 dpi switchable.(continue to press the right and middle button at the same time
in 3 seconds to change dpi)

2*AAA Alkaline batteries included.

Battery compartment cover

A wrong battery placement
may cause batteries overheat.

The unit offers a strong power saving management. Once the mouse accesses the sleeping mode, " to click any
button of the mouse" is compulsory to wake it up.

Power on/off:

There is a Power on/off switch designed to save the batteries power while non-usage of a longer period.
User can push DPI button to change the resolution. The LED on top case will be flashed when dpi has been
sucessfully swithced.

2 * AAA batteries

Mouse

Wheel button

Low power indicator

Battery cover

ID reset button
Power on/off switch

Receiver

Internet Forward & Backward button

Receiver

A. Hardware Installation

1. Insert the batteries

a. Remove the battery compartment cover on the bottom case of the mouse.
b. Fit in the batteries accordingly to the diagram indicated in the battery cabinet.
c. Close the battery compartment cover properly.
d. Make sure the Power on-off swich on the bottom of the mouse is ON.
e. The Low Power LED on the top case will blink 3 seconds if the mouse power is on.

Pull out the receiver

2. Connect the receiver

a. Turn on your PC.
b. Connect the receivere to USB port on PC.

PC

USB port

3. Communication : The mouse & the receiver

The 2.4Ghz RF mouse features a dual-way transmission technology which enables the
mouse and the receiver auto-communication.

A. Auto-link mode

1. Make sure the Power On-Off Switch on the bottom of the mouse is ON.

2. Operate the mouse, and cursor's movement is mapping mouse movement. Now the
mouse and the receiver is auto-linked successfully.