Elba 6222MC, 6333MC Instruction Manual

BEFORE YOU CALL FOR SERVICE

Before calling for service, be sure you read the following to avoid

an unnecessary service call.

TROUBLE

CAUSE

RE ME DY

After the ignition knob is
released, the flames are
extinguished.

Although there are ignitions,
the burners do no light on.

Uneven flame
The flames become yellowish.
The flames are extinguished
while the unit is in use.

Abnormal sounds during
combustion.

Smell of gas.

The ignition knob is not turned
on properly.

Air is entrapped in the rubber
gas hose.

The ignition spark device is
dirty or wet.
The rubber hose is bent.

Short of gas supply
The air adjaster is not in a
fixed position.

The slits in the burner caps
are clogged.
The burner caps are not
mounted properly.

Gas leakage from cracks of
rubber hose.
Loose connection of rubber hose.

Turn it counter clockwise.

Open the main valve.
Repeat turning it on
several times.

Replace gas cylinder.
Set it to desired position
properly. See figure#18

Clean the cap.

Mount them in place.

Replace it.
Secure the rubber hose
with the hose clamp.

※ Consult your dealer if you may not solve problem.Be sure to turn off the main cock.

WHEN SERVICE IS REQUIRED

Turn off the gas supply main cock and consult with your dealer for service or
call your nearest authorized service agency.

When calling service,give the following information:

1.Your name,address and phone number.

2.Model name and serial number,and date of purchase.

3.Problem in detail.

4.If you incur any problems,please take the stove to our service
department for repair.

INSTRUCTION MANUAL

CONTENTS

FEATURE DIAGRAM
INSTALLATION INSTRUCTIONS
HOW TO OPERATE
IMPORTANT SAFETY INSTRUCTIONS
ADJUSTMENT OF COMBUSTION
CARE OF YOUR GAS COOKER
BEFORE YOU CALL FOR SERVICE

1
1
2

3~4

5
6
7

GLASS STOVE

READ AND FOLLOW INSTRUCTION MANUAL BEFORE USE.

Ignition pin is far from the ring
cap

Install the battery wrongly

More the ignition pin and

keep 3-5mm from the ring cap

Install the battery correcily.

Clean or dry up.

Install if properly or replace it

7

PRECAUTIONS

USE ONLY THE TYPE OF GAS SPECIFIED ON Sheet 1:

Model No

Gas Used

Pressure

Heat flow Rate

EGH6022

LPG

2800Pa

Left:3.4Kw/h
Right:3.4Kw/h

Left:3.4Kw/h
Mid:1.0Kw/h
Right:3.4Kw/h

Do not place the unit near flammable materials. E.g. curtains, draperies, etc.

Be sure to turn off the burners and main cock if the unit is not in use.

Use a heat proof panel to protect walls where as required.

(For further information, refer to INSTALLATION INSTRUCTIONS on page 1)

ENSURE FIRE SAFETY

USE THE UNIT IN A WELL VENTILATED ROOM

Ensure proper ventilation. If the unit is used in a poorly ventilated room the air will be vitiated

and may be harmful to health.

PREVENT GAS LEAKS

Use a rubber gas hose of the approved type only. Do not use a vinyl hose as it

may not resist high temperatures and may be softened by heat.

While using the unit, occasionally check that the burners are lit .

After use, turn off the burners and stop gas flow. With the main cock. Especially make

sure the main cock is off before going to bed or a way from home.

In case of gas leaks, turn off the main cock and ventilate the room immediately

by opening windows and doors. Please contact your dealer of gas company.

WARNING:

In case of gas leaks, DO NOT turn fans or other electrical appliances on or off. DO NOT

light a match or use a lighter.

CAUTION WHEN USING

1.USE THE UNIT FOR COOKING PURPOSES ONLY TO PREVENT FIRE HAZARD

Do not use the unit for purposes other than cooking e.g. To burn charcoal, briquette.

Do not hang up clothes, towels, etc. To dry over the unit.

2. DO NOT USE OVERSIZED HOT PLATE WHICH TOTALLY COVERS THE
BURNER SURFACE

As air supply may be restricted, it will result in poor Combustion. Also the pan supports,

cook top and unit base may be heated abnormally.

3.DO NOT USE A LARGE IRON PLATE TO COVER BURNERS

4. IN CASE OF TROUBLE

If there are any signs of abnormal combustion, including strange sounds when the burners are

lit, turn off the burners and the main cock lit, turn off the burners and the main cock immediately

and contact your dealer.

5.WHEN THE UNIT WILL NOT BE USED FOR LONG TIME

Make sure the main cock is turned off.

If you wish to stow away the unit, you must ask your gas supplier to disconnect it for you,

and to connect it when you wish to use it again.

4

Figure #7

3.TURNING OFF UNIT

a- turn the ignition knob clockwise up to its original

position without pressing it.

b- after use. Make sure to turn off the main clock.

Remark:

When the burner is shut off, it may make a noise,

this normal.

For all the gas stoves with flameout device, it can automatically stop the gas distribution on
purpose of protection in case the flame suddenly gets out.

Make sure to operate the unit carefully as below:

1.Push the gas control knob in and turn towards the MAX position (anti-clockwise) until the
burner has been lit and last about 10 seconds. Then release the gas control knob. If the burner is
off when you release the gas control knob, turn the knob back to OFF and try again until the
burner ignite.

2.When the spilling water, soup or wind cause the unit flameout, the flameout device will
automatically close the gas distribution. For the sake of safety, to make sure turn the gas
control knob to OFF position immediately and to check if there is some dirt like soup, drip
etc on the surface of the flame-checking thermocouple. If so, keep it clean after the unit cool
down to avoid using difficultly next time.

3.Be careful not to impinge against the flame-checking thermocouple by the tough tools.

How to operate the unit with flameout protection

EGH6222

LPG

2800Pa

Left:3.4Kw/h
Right:3.4Kw/h

EGH6033

LPG

2800Pa

Left:3.4Kw/h
Mid:1.0Kw/h
Right:3.4Kw/h

EGH6333

LPG

2800Pa