Elation DLED 12 BRICK User Manual

PROFESSIONAL HIGH POWER LED USER’S MANUAL

DLED 12 BRICK

KEEP THIS MANUAL FOR FUTURE NEEDS

For your own safety , please read this user manual carefully before you initial start-up.

Keep this device away from rain and moisture!
Unplug mains lead before opening the housing!

Every person involved with the installation, operation and maintenance of this

device has to

- be qualified

- follow the instructions of this manual

- consider this manual to be part of the total product

- keep this manual for the entire service life of the product

- pass this manual on to every further owner or user of the product

- download the latest version of the user manual from the Internet

INTRODUCTION:

Thank you for having chosen this professional LED lighting.

You will see you have acquired a powerful and versatile device.

Unpack the device. Inside the box you should find:

1. The fixture device

2. Two power cable

3. An XLR connection cable

4. A safety cable and this manual

Please check carefully that there is no damage caused by transportation. Should

there be any, consult your dealer and don’t install this device.

- 2 - V1.0 01NR

SAFETY INSTRUCTIONS

CAUTION

Be very careful during installation. Since you will be working with a dangerous

voltage you can suffer a life-threatening electric sh ock when touching live wires.

This device has left the factory in perfect condition. In order to maintain this

condition and to ensure a safe operation, it is absolutely necessary for the user to

follow the safety instructions and warning notes written in this user manual.

If the device has been exposed to temperature changes due to environmental

changes, do not switch it on immediately. The arising condensation could damage

the device. Leave the device switched off until it has reached room temperature.

This device falls under protection-class I. Therefore it is essential that the device

should be earthed.

The electric connection must carry out by qualified person.

If the external flexible cable or cord of this luminaire is damaged, it shall be

exclusively replaced by the manufacturer or his service agent or a similar qualified

person in order to avoid a hazard.

Make sure that the available voltage is not higher than stated at the end of this

manual.

Make sure the power cord is never crimped or damaged by sharp edges. If this

would be the case, replacement of the cable must be done by an authorized dealer.

Always disconnect from the mains, when the device is not in use or before cleaning

- 3 - V1.0 01NR

it. Only handle the power cord by the plug. Never pull out the plug by tugging the
power cord.

During initial start-up some smoke or smell may arise. This is a normal process and

does not necessarily mean that the device is defective, it should decrease gradually.

CAUTION

Never touch the device during operation!

The housing may heat up

CAUTION

Never look directly into the light source,

as sensitive persons may suffer an epileptic shock.

Please be aware that damages caused by manual modifications to the device are not

subject to warranty. Keep away from children and non-professionals.

warran

Important:

Damages caused by the disregard of this user manual are not subject to

ty. The dealer will not accept liability for any resulting defects or problems.

- 4 - V1.0 01NR