ELANT EL7104CS, EL7104CN Datasheet
EL7104C, EL7114C
High Speed, Single Channel, Power MOSFET Drivers
EL7104C, EL7114C
Features
• Industry-standard driver
replacement
• Improved response times
• Matched rise and fall times
• Reduced clock skew
• Low output impedance
• Low input capacitance
• High noise immunity
• Improved clocking rate
• Low supply current
• Wide operating range
• Separate drain connections
Applications
• Clock/line drivers
• CCD drivers
• Ultrasound transducer drivers
• Power MOSFET drivers
• Switch mode power supplies
• Resonant charging
• Cascoded drivers
Ordering Information
Part No. Package Tape & Reel Outline #
EL7154CN 8-Pin PDIP MDP0031
EL7154CS 8-Pin SO MDP0027
General Description
The EL7104C and EL7114C ICs are matched driver ICs that improve
the operation of the industry-standard TC-4420/29 clock drivers. The
Elantec versions are very high speed drivers capable of delivering
peak currents of 1A into highly capacitive loads. The high speed performance is achieved by means of a proprietary “Turbo-Driver” circuit
that speeds up input stages by tapping the wider voltage swing at the
output. Improved speed and drive capability are enhanced by matched
rise and fall delay times. These matched delays maintain the integrity
of input-to-output pulse-widths to reduce timing errors and clock skew
problems. This improved performance is accompanied by a 10-fold
reduction in supply currents over bipolar drivers, yet without the delay
time problems commonly associated with CMOS drivers.
Connection Diagrams
GND
1
V+
2
IN
3
NC
4
EL7104C
Non-inverting Driver
8
7
6
5
V+
P_OUT
N_OUT
GND
1
V+
2
IN
3
NC
4
GND
EL7114C
Inverting Driver
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
8
7
6
5
V+
P_OUT
N_OUT
GND
August 20, 2001
EL7104C, EL7114C
High Speed, Single Channel, Power MOSFET Drivers
Absolute Maximum Ratings (T
Supply (V+ to GND) 16.5V
Input Pins -0.3V to +0.3V above V+
EL7104C, EL7114C
Peak Output Current 4A
Storage Temperature Range -65°C to +150°C
Ambient Operating Temperature -40°C to +85°C
Important Note:
All parameters having Min/Max specifications are guaranteed. Typ values are for information purposes only. Unless otherwise noted, all tests are at the
specified temperature and are pulsed tests, therefore: TJ = TC = TA.
= 25°C)
A
Operating Junction Temperature +125°C
Power Dissipation:
SO 570mW
PDIP 1050mW
DC Electrical Characteristics
TA = 25°C, V+ = 15V unless otherwise specified.
Parameter Description Test Conditions Min Typ Max Unit
Input
V
IH
I
IH
V
IL
I
IL
V
HVS
Output
R
OH
R
OL
I
OUT
I
PK
I
DC
Power Supply
I
S
V
S
Logic “1” Input Voltage 2.4 V
Logic “1” Input Current @V+ 0.1 10 µA
Logic “0” Input Voltage 0.8 V
Logic “0” Input Current @0V 0.1 10 µA
Input Hysteresis 0.3 V
Pull-Up Resistance I
Pull-Down Resistance I
Output Leakage Current V+/GND 0.2 10 µA
Peak Output Current Source
Continuous Output Current Source/Sink 200 mA
Power Supply Current Input = V+ EL7104C
Operating Voltage 4.5 16 V
= -100 mA 1.5 4 Ω
OUT
= +100 mA 2 4 Ω
OUT
Sink
EL7114C
4.0
4.0
4.5
1
7.5
2.5
A
mA
AC Electrical Characteristics
TA = 25°C, V = 15V unless otherwise specified.
Parameter Description Test Conditions Min Typ Max Unit
Switching Characteristics (VDD = VH = 12V; VL = -3V)
t
R
t
F
t
D-ON
t
D-OFF
Rise Time CL = 1000 pF 7.5 ns
CL = 2000 pF 10 20 ns
Fall Time CL = 1000 pF 10 ns
CL = 2000 pF 15 20 ns
Turn-On Delay Time See Timing Table 18 25 ns
Turn-Off Delay Time See Timing Table 18 25 ns
2
Timing Table
Input
Inverted
Output
EL7114C
Non-
inverted
Output
EL7104C, EL7114C
EL7104C, EL7114C
High Speed, Single Channel, Power MOSFET Drivers
5V
2.5V
0
90%
10%
90%
10%
Standard Test Configuration
Signal
Input
1 8
2
4 5
t
D1
D.U.T.
t
F
t
R
6
7
2000pF
t
D2
4.7µF
Output
Signal
t
R
t
F
3
Loading...