ELANT EL6280CU, EL6280CL Datasheet

EL6280C - Product Brief
Dual Laser Driver with APC Amp
EL6280C - Product Brief
Features
• Read + 3Write Channel laser driver with oscillator and fast I/V amplifier plus a separate ROM laser driver with oscillator
• 200V/µs I/V amplifier
• 100X gain, 100mA low noise read channel
• 200X gain, 200mA write channel plus two 100X gain, 100mA write channels
• 500MHz, 100mA
Oscillator
P-P
• Write Rise/Fall times = 0.8ns
• Single +5V supply
Applications
• Combo CD-RW + DVD-ROM
• CD-RW to 16X
• CD-R to 32X
• Writable Optical Disk Drives
Ordering Information
Part No. Temp. Range Package Outline #
EL6280CU 0°C to +70°C QSOP-24 MDP0040
EL6280CL LPP-24 MDP0046
General Description
The EL6280C is a combination read + 3 write level laser driver and IV amplifier, with an extra read + oscillator ROM channel for use in dual­laser ‘Combo’ drivers. A separate (amplitude and frequency) oscilla­tor modulates the selected output for laser noise reduction during read or write. All these functions are provided in a 24 lead QSOP package.
The CD pin when high selects the CD (write) laser. Positive current supplied to the IIN lines, through a user selected resistor, allow the full scale range of each amplifier to be matched to the full scale range of the users control DACs. When the write laser is selected, and the WEN pins are switched low, the respective current is summed to the output with 1ns rise and fall times. Write channel 2 has 200mA output capability with an 200X gain amplifier.
The 100mA
(max) oscillator is switched on and off by the OSCEN
P-P
line. The CD line allows the oscillator to operate at different ampli­tudes and frequencies for each laser.
The entire chip is powered down when ENABLE is low. The user can define the gain of the I/V amplifier. With a slew rate of 200V/µs, the I/V amplifier can normally settle to 1% within 30ns.
Connection Diagram
1
VOUT
2
VREF
3
IINR
4
IIN2
5
RF1
6
IIN3
7
IIN4
8
RF2
9
WEN2
10
CD
11
WEN3
12
WEN4
PDIN
VDD
VDD
IOUT1
GND
GND
RAMP1
RAMP2
ENABLE
OSCEN
IOUT2
VDD
24
IINR
VREF
VOUT
PDIN
23
22
IIN2
21
RF1
20
IIN3
19
IIN4
18
17
WEN2
16
15
14
13
CD
24
1 19
2
3
4
5
6
7
8
WEN3
22
23
9
10 VCC
WEN4
VCCOSCEN 20
21
VCC
IOUT1
18
17
GND
16
GND
15
RAMP1RF2
14
RAMP2
13
ENABLE
12
11
IOUT2
October 25, 2001
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
EL6280C - Product Brief
Dual Laser Driver with APC Amp
EL6280C - Product Brief
General Disclaimer
Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the cir­cuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described herein and makes no representations that they are free from patent infringement.
WARNING - Life Support Policy
Elantec, Inc. products are not authorized for and should not be used within Life Support Systems without the specific written consent of Elantec, Inc. Life Support systems are equipment intended to sup-
Elantec Semiconductor, Inc.
675 Trade Zone Blvd. Milpitas, CA 95035 Telephone: (408) 945-1323
(888) ELANTEC Fax: (408) 945-9305 European Office: +44-118-977-6020 Japan Technical Center: +81-45-682-5820
port or sustain life and whose failure to perform when properly used in accordance with instructions provided can be reasonably expected to result in significant personal injury or death. Users con­templating application of Elantec, Inc. Products in Life Support Systems are requested to contact Elantec, Inc. factory headquarters to establish suitable terms & conditions for these applications. Elan­tec, Inc.’s warranty is limited to replacement of defective components and does not cover injury to persons or property or other consequential damages.
October 25, 2001
2
Printed in U.S.A.
Loading...