ELANT EL1510CS-T7, EL1510CS-T13, EL1510CS, EL1510CL-T7, EL1510CL Datasheet
EL1510C - Product Brief
Medium Power Differential Line Driver
EL1510C - Product Brief
Features
• 40V
• -85dBc typical driver output
• Low quiescent current of 7.5mA
differential output drive
P-P
into 100Ω
distortion at full output at 150kHz
per amplifier
Applications
• ADSL G.lite CO line driving
• G.SHDSL, HDSL2 line drivers
• ADSL full rate CPE line driving
• Video distribution amplifiers
• Video twisted-pair line drivers
Ordering Information
Part No Package Tape & Reel Outline #
EL1510CS 8-Pin SO - MDP0027
EL1510CS-T7 8-Pin SO 7” MDP0027
EL1510CS-T13 8-Pin SO 13” MDP0027
EL1510CL 8-Pin LPP - MDP0047
EL1510CL-T7 8-Pin LPP 7” MDP0047
EL1510CL-T13 8-Pin LPP 13” MDP0047
General Description
The EL1510C is a dual operational amplifier designed for central
office and customer premise line driving in both SDSL and ADSL
solutions. This device features a high drive capability of 250mA while
consuming only 7.5mA of supply current per amplifier, operating
from ±12V supplies. This driver achieves a typical distortion of less
than -85dBc, at 150kHz into a 25Ω load. The EL1510CL is available
in the power 8-pin LPP package and is specified for operation over the
full -40°C to +85°C temperature range. The LPP package has the
potential for a very low junction to ambient thermal resistance of
43°C/W, making it suitable for high power applications. The
EL1510CS is in the 8-pin SO package and thus is limited to applications where the power dissipation in the device is less than 781mW.
The EL1510C is ideal for CPE modem applications in ADSL, HDSL2,
G.SHDSL, and VDSL.
Connection Diagrams
INA-
INA+
GND
1
2
-
+
3
4
8
VSOUTA
7
OUTB
INB-
6
-
INB+
+
5
8-Pin SO
1
OUTA
2
INA-
INA+
GND
Note: All information contained in this data sheet has been carefully checked and is believed to be accurate as of the date of publication; however, this data sheet cannot be a “controlled document”. Current revisions, if any, to these
specifications are maintained at the factory and are available upon your request. We recommend checking the revision level before finalization of your design documentation.
© 2001 Elantec Semiconductor, Inc.
3
4
+
Amp A
Amp B
8-Pin LPP Top View
8
VS
7
OUTB
6
+
INB-
5
INB+
September 18, 2001
EL1510C - Product Brief
Medium Power Differential Line Driver
EL1510C - Product Brief
General Disclaimer
Specifications contained in this data sheet are in effect as of the publication date shown. Elantec, Inc. reserves the right to make changes in the circuitry or specifications contained herein at any time without notice. Elantec, Inc. assumes no responsibility for the use of any circuits described
herein and makes no representations that they are free from patent infringement.
WARNING - Life Support Policy
Elantec, Inc. products are not authorized for and should not be used
within Life Support Systems without the specific written consent of
Elantec, Inc. Life Support systems are equipment intended to sup-
Elantec Semiconductor, Inc.
675 Trade Zone Blvd.
Milpitas, CA 95035
Telephone: (408) 945-1323
(888) ELANTEC
Fax: (408) 945-9305
European Office: +44-118-977-6020
Japan Technical Center: +81-45-682-5820
port or sustain life and whose failure to perform when properly used
in accordance with instructions provided can be reasonably
expected to result in significant personal injury or death. Users contemplating application of Elantec, Inc. Products in Life Support
Systems are requested to contact Elantec, Inc. factory headquarters
to establish suitable terms & conditions for these applications. Elantec, Inc.’s warranty is limited to replacement of defective
components and does not cover injury to persons or property or
other consequential damages.
September 18, 2001
2
Printed in U.S.A.
Loading...