ELAN Lighting TRANSCEIVER WS, RECEIVER WS User Manual

TRANSCEIVER WS

RECEIVER WS

User manual

On the Transmitter, press and hold the FUNCTION button until LINK begins ashing. All
registered Receivers linked to that Transmitter will be unlinked.

3.4 To unlink all Receivers

The TRANSCEIVER can be used as a Transmitter or Receiver. To switch mode between
Transmitter and Receiver, power o the unit, then hold the FUNCTION button while power on
the unit for 2 seconds. When DMX and MODE indicators turn o, then the unit is a Receiver.
Otherwise, it is a Transmitter.

3.5 To set a TRANSCEIVER to Transmit or Receive

I

MPORTANT INFORMATION!

In order to optimize the recovery and recycling of the materials that old
appliances contain and reduce the impact on human health and the
environment, ensure that this product is recycled at the end of its life.

5. Specifications

FCC Notice

5

• Frequency band: 2.4GHz

• Transmission distance: approx. 500m

• IP rating: IP20

• Power supply: AC 230V 50-60Hz

• Dimension: 145mm x 100mm x 57mm

• Weight: 1.40kg

Note: The Receiver will stay linked/logged on to the Transmitter no matter DMX
signal or power is cut o. The log-in information is stored in an EEPROM and will not
be erased.

•

This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference,and (2) this device must accept any
interference received, including interference that may cause undesired operation.

• Changes or modications not expressly approved by the manufacturer responsible
for compliance could avoid the user’s authority to operate the equipment.