Temperature controls
REFRIGERATOR LARDER
FREEZER FRIDGE FREEZER
6
ADJUSTING THE THERMOSTAT
The internal temperature of your Elan is
controlled by a thermostat as shown below
(Fig. 3).
The dial has 6 temperature settings.
When your Elan was manufactured the dial
was set to between 3 and 5, the correct setting
for use in normal room temperature. You can
adjust the temperature by turning the dial.
Setting 6 will make the Fridge or Freezer coldest.
It may not operate at the correct temperature
if it is in a particularly hot or particularly cold
room or if you often open the door.
HOW TO USE THE DEFROST TRAY
The defrost tray ensures that your Elan always
runs efficiently. The table below (Fig. 4) shows
which position the flap should be in.
USING FAST FREEZE
Your Freezer has a Fast Freeze feature, which
makes your freezer colder (approx -28°C) than
its usual operating temperature of
approximately -18°C. Turn the thermostat dial
to 6 to activate Fast Freeze. Fast Freeze has
two uses.
After defrosting, or when you first turn your
freezer on, your freezer will cool down
quicker, enabling you to use it sooner. When
freezing fresh food, the lower temperature
will freeze quicker and keep in the goodness.
You should use the Fast Freeze feature
sparingly to conserve energy.
Fast Freeze doesn’t cancel automatically, you
will have to turn the thermostat dial to a
lower setting to turn it off again.
355, 455, & 555
ENERGY SAVING
By gently circulating cold air throughout the
cabinet, food stays fresher longer. However,
the turbo fan uses a very small amount of
electricity. When stocks are low you can
conserve energy by turning off the fan using
the Energy saving switch. The rocker switch
shown below (Fig. 5) is located on the inside
of your Elan’s door frame.
FRIDGE FREEZER
FREEZERS
Model Flap In a very Average In a very
to use cold room temp. room warm room
ER450 Small Out In In
ER550 Large Out Out In
ER750 Small In Out In
Large Out In In
Flap Out Flap In
Fig. 3
Fig. 4
Fig. 5