EKWB EK-Classic GPU Water Block Trio RTX 2080 Ti D-RGB Service Manual

EK-Classic GPU Water Block

Trio RTX 2080 Ti D-RGB

GPU WATER BLOCK

1st Revision, Jun 12th 2020

INSTALLATION MANUAL

The product is compatible with RTX 2080 Ti Trio graphics card. It
is intended for installing only by expert users. Please consult with a
qualified tehnician for installation. Improper installation may result
in damage to your equipment. EK Water Blocks assumes no liability
whatsoever, expressed or implied, for the use of these products, not
their installation. The following instructions are to change without
notice. Please visit our web side www.ekwb.com for updates. Before
installation of this product please read important notice, disclosure
and warranty conditions printed on the back of the box.

Before you start using this produc t please follow these basic guidelines:

Please carefully read the manual throughly before beginning
with the installation process!

Please remove your graphics card from computer to assure
safest mounting process in order to prevent any possible
damages to your GPU and/or graphics card circuit board(PCB).

The EK fittings require only a small amount of force to screw
them firmly in place since the liquid seal is ensured by the
rubber O-ring gaskets.

Do not use pure dist illed water! For best results EK recommends
the use of EK-CyroFuel coolants!

- 2 -

TABLE OF CONTENT

PREPARING YOUR GRAPHICS CARD 4
INSTALLING THE WATER BLOCK 7
CHECKING FOR CONTACTS 8
INSTALLATION OF FITTINGS AND TUBING 8
INSERTING THE CARD IN YOUR PC CASE 9
REQUIRED TOOLS 9
CONNECTING THE D-RGB LED STRIP 10
SUPPORT AND SERVICE 11
SOCIAL MEDIA 11

- 3 -

PREPARING YOUR GRAPHICS CARD

STEP 1

STEP 1
REMOVING FACTORY PROVIDED BACKPLATE

Remove all encircled screws using Phillips screwdriver. All heat
sink assembly screws should be removed, including self-adhesive
washers washers on the both sides of the PCB(if present).

STEP 2
REMOVING STOCK COOLER

Remove all encircled screws using Phillips screwdriver. All heat
sink assembly screws should be removed, including self-adhesive
washers on both sides of the PCB(if present). After you remove the
housing do not unplug the fans.

STEP 2

- 4 -