EKWB CPU Lignum operation manual
CPU Lignum
CPU WATER BLOCK
USER GUI DE
1st Revision, May 17th 2019
This product is intended for installation only by exper t users. Please
consult with a qualified technician for installation. Improper installation
may result in damage to your equipment. EK Water Blocks assumes no
liability whatsoever, expressed or implied, for the use of these products,
nor their installation. The following instructions are subject to change
without notice. Please visit our web site at www.ekwb.com for updates.
Before installation of this product please read important notice, disclosure
and warranty conditions printed on the back of the box.
Before you start using this product please follow these basic guidelines:
Please carefully read the manual before beginning with the
installation process!
The product must be in a non moist and temperature-stable
environment
Please remove your graphics card from the computer to assure
safest mounting process in order to prevent any possible damages
to your GPU and/or graphics card circuit board (PCB).
The EK fittings require only a small amount of force to screw them
firmly in place since the liquid seal is ensured by the rubber O-ring
gaskets.
The use of corrosion inhibiting coolants is always recommended for
any liquid cooling system.
Do not use pure distilled water! For best results EK recommends the
use of EK-CryoFuel coolants!
Make sure to thoroughly bleed air out of your water block, or you will
not reach optimal performance!
TABLE OF CONTENT
GENERAL INFORMATION ON WATER BLOCK COMPATIBILITY 4
WHAT IS ENCLOSED 4
QUICK INSTALLATION GUIDE
REPLACING THE JET PLATE PROCEDURE 5
INSTALLING THE WATER BLOCK 6
LGA20113 / 2066 SOCKET MOTHERBOARDS 6
LGA115X SOCKET MOTHERBOARDS 9
AMD® SOCKET MOTHERBOARDS 10
SUPPORT AND SERVICE 12
SOCIAL MEDIA 12
- 3 -
GENER AL INFORMATION ON WATER BLOCK COMPATIBILITY
This CPU liquid cooling unit is pre-assembled for use with modern Intel
desktop socket type motherboards. By default (out of the box) this water
block supports the following CPU sockets:
- Intel® Socket LGA-115x
- Intel® Socket LGA-2011(-3) / 2066
- AMD® socket AMx and FMx
WHAT IS ENCLOSED
The following items are enclosed with each EK-CPU Lignum
water block:
- EK-CPU Lignum water block.
- EK-LIgnumPreciseMount CPU mounting mechanism:
• M4 threaded thumb screws (4 pcs)
• LGA-2011 M4 threaded mounting studs (4 pcs)
• Springs (4 pcs)
• M4 threaded thumb nuts (4 pcs)
• Washers (4 pcs)
- EK-Supremacy Backplate
• Backplate rubber gasket
• Backplate for Intel® LGA-115x socket motherboards
• Backplate for AM4 socket motherboards
- AMD socket mounting plate
- Allen (hex) key 2.5mm
- Additional Jet plate:
• Jet J2 (0.8mm* thick)
- Thermal Grizzly Hydronaut (EKWB 1.0g) thermal grease
- EK-HTC Lignum 12mm fittings
- 4 -
Loading...