Ekselans CM 4HD-IP, 082008 User Manual

CM 4HD-IP

082008

HD digital modulator-IP streamer
4 HDMI-IP

User’s Manual

2

3

1 CM 4HD-IP – USER’S MANUAL

1.1 General Description

Number

Description

1

HDMI Inputs. Connection to the audio/video power supply

2

LED status of the inputs. Shall blink in green when the HDMI are connected

3

RJ45 Connector. IP output

2

1

3

4

Connect this part to the power
supply

Connect this part to the PC

2. Installation and wiring

1. Fasten the digital encoder-modulator module to a wall frame (CHM TR) or a rack chassis
(CHR TR). To this end assemble on the upper rear part of the module the supplied metal part,
as is shown in the picture

2. Connect the power supply (FA 524) to the module or either connect same to the previous
module using the supplied power cable

3. Connect the HD audio/video power supply to the HDMI connectors

4. So as to program the module, connect the FA 524 power supply to a PC via a USB-USB
cable as follows:

5. Install the “CMManagement” software on the PC or the or the "EK Pro" software package
which is also included. Both programmes can be downloaded from the website

www.ekselansbyits.com, Documentation >> Software section.

6. Run the programming software on the PC (Important: connect the FA 524 power supply to
the PC before running the software so that the driver of the PC can correctly detect the
software).

5

3. Software Programming: CM management

The "CM management" programming software enables the programming and running of all
modules of the CM headend. The program is available only for Windows operating system (XP
version 7 and above).

Once downloaded from the website www.ekselansbyits.com, Documentation >> Software
section, having previously run the program with the PC connected to the USB port of the FA 524
power supply. In this fashion, it is ensured that the driver detects the core.

3.1.Main screen

The main screen of the "CM Management" software is as follows:

Through this function one can run and program all modules connected to the power supply.

Explained below is the function of each of the options: