Ekofires 1250 LED Installation & User's Instructions

INSTALLATION & USER INSTRUCTIONS

All instructions must be handed to the user for

safekeeping.

MODELS COVERED BY THESE INSTRUCTIONS

EF09-19
1250 LED ELECTRIC STOVE

*VARIOU S CO LOUR S AVAILA BLE

LED ELECTRIC STOVE

Please note : Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Focal Point Fires plc. You are not per­mitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.

1

Revision A - 10/16

© 2016 Focal Point Fires plc.

GB IE

MODEL SHOWN: EKO 1250 ARCHED LED ELECTRIC STOVE

Christchurch, Dorset BH23 2BT

Tel: [phone]
Fax: [phone]
www.ekofires.co.uk

e-mail: [e-mail]

IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

When using this electrical appliance, basic precautions should be followed to reduce the risk
of fire, electric shock and injury to person, including the following:

• This heater must be used on an AC supply only and the voltage marked on the heater’s
rating label must correspond to the supply voltage.

• DO NOT switch the appliance on until it is properly installed as described in this
manual.

• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance pro­vided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user maintenance.

• CAUTION: Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

• The heater must not be located immediately below a socket-outlet.

• DO NOT use this heater in the immediate surroundings of a bath, a shower or a swim-
ming pool.

• WARNING: In order to avoid overheating, do not cover the heater.

• DO NOT use this heater with a programmer, timer, separate remote-control system or
any other device that switches the heater on automatically, since a fire risk exists if the
heater is covered or positioned incorrectly.

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.

• Keep furniture, curtains and other fabric material away from the appliance.

• DO NOT leave the appliance unattended during use.

• From time to time, check the cord for damage. Never use the appliance if the cord or any
part of the appliance shows signs of damage.

1.0 IMPORTANT NOTES

I N S TA L L AT I O N & U S E R I N S T RU C T I O N S

2

GB IE

Section Contents Page No.

1.0 Important Notes 2

2.0 Installation Requirements 3

3.0 Appliance Data 3

4.0 Unpacking the Appliance 3

5.0 Component Checklist 3

6.0 Installing the Appliance 3

7.0 Operating the Appliance 4

8.0 Safety Cutout System 5

Section Contents Page No.

9.0 Maintenance 5

10.0 Cleaning 5

11.0 Spares 5

12.0 Servicing 6

13.0 Appliance Dimensions 6

14.0 Troubleshooting Guide 7

15.0 Guarantee - Terms and Conditions 7

© 2016 Focal Point Fires plc.

3

© 2016 Focal Point Fires plc.

QUANTITY DESCRIPTION

1 Heater main body with decorative castings
1 Instruction booklet
1 Remote control handset
2 Levelling feet

5.0 COMPONENT CHECKLIST

Read all the instructions before continuing to unpack or install this appliance. Carefully lift the appliance from the carton. Check
that the contents correlate with the component checklist below. Please dispose of all packaging with care at your local recycling
centre.

4.0 UNPACKING THE APPLIANCE

2.0 INSTALLATION REQUIREMENTS

3.0 APPLIANCE DATA

Supply Voltage and rating power : 220-240V AC 50Hz, 1500 - 1800W Fuse Rating : 13 Amp
Heating Elements : 1500 - 1800W Lighting : LED Light Strip
Location : Indoor use only Supply plug/cord : BS1363/1.8 metres length

The appliance is supplied with a pre-wired three pin BS1363 plug (13Amp fuse rated) and 1.8 metres of electrical flex. It is therefore
necessary for a suitable electrical socket to be located within this distance of the appliance and be easily accessible. The stove may be
installed on a combustible or non-combustible floor, however the heater outlet is underneath the stove and certain types of floor cov­ering may be affected by the heat produced by the stove. The ability of the floor covering to withstand the heat produced by the stove
should be ascertained before proceeding with the installation of the stove. If in doubt then the stove should be mounted on a non-com­bustible hearth or plinth which extends at least 150mm in front of the stove.This appliance should be positioned on a firm level surface.
If the stove is to be sited in a fire surround then the suitability of the surround for use with electrical heaters should be established with
the fire surround manufacturer.If fitted into an open draught fireplace, it is advisable to block off the chimney to reduce the risk of
draught through the stove which may cause the safety cut out system in the fan heater to operate.

• DO NOT run the mains cable under carpets, rugs etc.

• DO NOT cover or obstruct the heater in any way. Overheating will result if it is acci-
dentally covered.

• Never immerse the product in water or any other liquids.

• DO NOT use the appliance outdoors.

• Before cleaning the appliance, ensure it is unplugged from the power and that it is com­pletely cool.

• DO NOT clean the appliance with abrasive chemicals.

• Never use accessories that are not recommended or supplied by the manufacturer. It
could cause danger to the user or damage to the appliance.

• DO NOT insert or allow foreign objects to enter the inlet or outlet vents as this may
result in electric shock, fire or damage to the appliance.

• DO NOT install the fire using an extension cord.

• Unplug from the mains supply if the appliance is not to be used for long periods.

1.0 IMPORTANT NOTES - CONTINUED

GB IE

CAUTION: DO NOT CONNECT THE APPLIANCE TO THE ELECTRICAL SUPPLY AT THIS TIME

Situate the LED stove in the desired location. If the surface is uneven, fit two levelling feet behind the two front cast legs. Unscrew in a anti
clockwise orientation to extend the feet and clockwise to contract the front legs. The fires levelness can be checked by using a spirit level.

Before finally fitting the appliance into its location, ensure that the mains cable and plug are properly routed.

6.0 INSTALLING THE APPLIANCE