Ekofires 1011 GRAND LED ELECTRIC, EF11-16 Installation & User's Instructions

INSTALLATION & USER INSTRUCTIONS

All instructions must be handed to the user for

safekeeping.

MODELS COVERED BY THESE INSTRUCTIONS

1011 GRAND LED ELECTRIC
EF11-16

Please note : Except where otherwise stated, all rights,
including copyright in the text, images and layout of this
booklet is owned by Focal Point Fires plc. You are not per­mitted to copy or adapt any of the content without the
prior written permission of Focal Point Fires plc.

1

Revision A - 04/16

© 2016 Focal Point Fires plc.

MODEL SHOWN: EKO 1011 GRAND

GB IE

WALL MOUNTED LED ELECTRIC FIRE

Christchurch, Dorset BH23 2BT

Tel: [phone]
Fax: [phone]
www.ekofires.co.uk

e-mail: [e-mail]

1.0 PRELIMINARY NOTES

I N S TA L L AT I O N & U S E R I N S T RU C T I O N S

2

GB IE

© 2016 Focal Point Fires plc.

Section Contents Page No.

1.0 Preliminary Notes 2

2.0 Appliance Data 3

3.0 Electrical Installation Requirements 3

4.0 Component Checklist 3

5.0 Site Requirements 3

6.0 Clearances to Combustible Materials 4

7.0 Unpacking the Appliance 4

8.0 Installation 4

Section Contents Page No.

8.1 Removing the Front Glass 6

8.2 Installing the Crystal Embers 7

9.0 Operating the Appliance 7

10.0 Safety cut-out System 7

11.0 Cleaning and Maintenance 8

12.0 Servicing 8

13.0 Appliance Dimensions 8

14.0 Guarantee - Terms and Conditions 9

IMPORTANT - THESE INSTRUCTIONS SHOULD BE READ CAREFULLY

AND RETAINED FOR FUTURE REFERENCE.

When using this electrical appliance, basic precautions should be followed to reduce the risk
of fire, electric shock and injury to person, including the following:

• This heater must be used on an AC supply only and the voltage marked on the heater’s
rating label must correspond to the supply voltage.

• DO NOT switch the appliance on until it is properly installed as described in this
manual.

• This appliance can be used by children aged from 8 years and above and persons with
reduced physical, sensory or mental capabilities or lack of experience and knowledge if they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children shall not play with the appliance. Cleaning and
user maintenance shall not be made by children without supervision.

• Children of less than 3 years should be kept away unless continuously supervised.
Children aged from 3 years and less than 8 years shall only switch on/off the appliance pro­vided that it has been placed or installed in its intended normal operating position and they
have been given supervision or instruction concerning use of the appliance in a safe way and
understand the hazards involved. Children aged from 3 years and less than 8 years shall not
plug in, regulate and clean the appliance or perform user maintenance.

• CAUTION: Some parts of this product can become very hot and cause burns.
Particular attention has to be given where children and vulnerable people are present.

• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.

• The heater must not be located immediately below a socket-outlet.

• DO NOT use this heater in the immediate surroundings of a bath, a shower or a swim-
ming pool.

• WARNING: In order to avoid overheating, do not cover the heater.

• DO NOT use this heater with a programmer, timer, separate remote-control system or
any other device that switches the heater on automatically, since a fire risk exists if the
heater is covered or positioned incorrectly.

• CAUTION: In order to avoid a hazard due to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.

• Keep furniture, curtains and other fabric material away from the appliance.

• DO NOT leave the appliance unattended during use.

• From time to time, check the cord for damage. Never use the appliance if the cord or any
part of the appliance shows signs of damage.

• DO NOT run the mains cable under carpets, rugs etc.

• DO NOT cover or obstruct the heater in any way. Overheating will result if it is acci-
dentally covered.

5.0 SITE REQUIREMENTS

© 2016 Focal Point Fires plc.

3

3.0 ELECTRICAL INSTALLATION REQUIREMENTS

• Never immerse the product in water or any other liquids.

• DO NOT use the appliance outdoors.

• Before cleaning the appliance, ensure it is unplugged from the power and that it is com­pletely cool.

• DO NOT clean the appliance with abrasive chemicals.

• Never use accessories that are not recommended or supplied by the manufacturer. It
could cause danger to the user or damage to the appliance.

• DO NOT insert or allow foreign objects to enter the inlet or outlet vents as this may
result in electric shock, fire or damage to the appliance.

• DO NOT install the fire using an extension cord.

• Unplug from the mains supply if the appliance is not to be used for long periods.

2.0 APPLIANCE DATA

Weight (kg): 17.0 kg Supply Cord: 1.8 metres
Dimensions (mm): H 965 x W 432 x D 152 Fuse: 13Amp

Supply Voltage and rating power: 220-240V a.c. 50Hz, 1800W Location: Indoor Use

Heating Elements: 2 x 900Watts (1.8kW) Lighting: LED

The appliance is supplied with a pre-wired three pin plug (13 Amp fuse rated), and 1.8 metre cable. A standard switched outlet/wall socket,
(including earth provision), must therefore be located within this distance, and be easily accessible in order to isolate the supply for maintenance
and cleaning. This socket must not be mounted behind or above the appliance.

IMPORTANT: THIS APPLIANCE MUST BE EARTHED.

1.0 PRELIMINARY NOTES - CONTINUED

GB IE

It should be noted that the appliance creates warm convected air currents. These currents move heat from the room
surroundings to, and up the wall surfaces adjacent to the heater.
Installing the heater next to these types of wall coverings or operating the heater where impurities in the air, (such as tobacco
smoke) exist, may slightly discolour wall finishing.
If the appliance is to be mounted on a dry lined or timber framed construction then the integrity and ability of the wall to
carry the weight of the appliance must be confirmed. It is important in these circumstances that any vapour barrier and/or
structural members of the house frame are not damaged.
If you are unsure of the ability of the wall to carry the weight and/or which type of wall fixing to use, you should take
professional advice and obtain the correct fixings. Alternatively, find a more suitable wall location.

DO NOT

• mount on a ceiling or floor

• recess any part of the appliance into the wall, or run the supply cable under carpets.

• site any electrical equipment e.g. plasma screen TV sets etc, on the wall below the appliance.

• site in a position where curtains or drapes could cover the appliance, or other soft materials could cover e.g. below a coat
rack

• site behind an opening door where mechanical impact/damage could occur

• site where the supply cable would become a trip hazard

• sit, stand or forcefully pull on the appliance

• obstruct, cover or force items into the openings

• use the heater to dry clothes

• site/use in an outdoor location(s)
It is important that the following clearances are maintained from the appliance to combustible materials. These clearances are
dependent on the mounting location as defined below:

4.0 COMPONENT CHECKLIST

QUANTITY DESCRIPTION

1 Heater unit
1 Decorative glass facia
1 Remote control handset
1 Instruction Booklet
1 Bag of crystals
5 Fixing screws
5 Wall plugs