Ekasand 75 x 100 mm Operator Instructions Manual
EKASAND
EKASAND TOOLS
© EKASAND•0701
75 x 100 mm (3 x 4 in.)
Orbital Sander
Features:
• Free Speed of 10,000 Orbits Per Minute
• Variable Speed Control with Palm Style On/Off Lever
• 3 Sizes of Ergonomic Cushion-Grips for comfort and
stability
•LowProleforOperatorControlandComfort
Operators Instructions
WARNING
Always wear safety
goggles to protect your
eyes.
Includes – Features and Suggested Applications, Please Read and Com-
ply, Assembly Drawing of Machines, Parts List, Proper Use of Tool, Work
Stations, Putting the Tool Into Service, Operating Instructions, EKASAND
Service Tools and Accessories, EKASAND Back-Up Pads™, EKASAND
Service Kit, EKASAND Warranty
• Rear Exhaust Directs Air away from work
• Suggested Applications:
Sanding and Finishing a Variety of Materials including
Wood, Metal, Plastic, Fiberglass Composites, Solid
Surfaces and other Sandable Surfaces
OIL DAILY
Oil daily for superior
Important
Read these instructions carefully before installing, operating, servicing or
repairing this tool. Keep these instructions in a safe, accessible location.
performance.
Please Read and Comply With
1) General Industry Safety & Health Regulations, Part 1910, OSHA 2206,
available from: Superintendent of Documents; Government Printing Of-
ce; Washington DC 20402
2) Safety Code for Portable Air Tools, ANSI B186.1 available from: American National Standards Institute, Inc.; 1430 Broadway; New York, NY
10018
3) State and Local Regulations.
Key parts of the above regulations are excerpted below. They are not in-
tended to be inclusive. Study and comply with all regulations.
1) TOOL INTENT – Tool shall be used only for purposes intended in its
design.
2) AIR SUPPLY – Test and operate tools at 90 PSIG (6.1 Bar) maximum
unless tool is marked otherwise. Use recommended airline lters -
regulators – lubricators (FRL).
3) UNUSUAL SOUND or VIBRATION – If tool vibrates or produces an
unusual sound, repair immediately for correction.
4) OPERATOR PROTECTIVE EQUIPMENT – Wear goggles or face
shield whenever tool is in operation. Other protective clothing shall be
worn, if necessary.
5) SAFETY MAINTENANCE PROGRAM – Employ a safety program to
provide inspection and maintenance of all phases of tool operation and
air supply equipment in accordance with “Safety Code for Portable Air
Tools.”
DOC 1114 1 04/26/06
EKASAND 75 x 100 mm (3 x 4 in.)
Orbital Sander
DOC 1114 2 04/26/06
Loading...