Eizo EX4 Calibration Sensor

User’s Manual

Calibration Sensor

Please read this User’s Manual carefully to familiarize yourself with safe and e󰀨ective usage.
Please retain this manual for future reference.

PRECAUTIONS

WARNING

If the unit begins to emit smoke, smells like something is burning, or makes strange noises,
disconnect all connections immediately and contact your local EIZO representative for advice.

Attempting to use a malfunctioning unit may result in re, electric shock, or equipment damage.

Do not disassemble or modify the unit and cable.

Not doing so may result in damage, re or electric shock.

Package Contents

English

Please contact your local EIZO representative for assistance if any of the listed items are missing
or damaged.

• EX4 (sensor)

• User’s Manual (This manual)

No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any
form or by any means, electronic, mechanical, or otherwise, without the prior written permission
of EIZO Corporation. EIZO Corporation is under no obligation to hold any submitted material or
information condential unless prior arrangements are made pursuant to EIZO Corporation’s
receipt of said information. Although every e󰀨ort has been made to ensure that this manual
provides up-to-date information, please note that this products specications are subject to
change without notice.

EIZO and EIZO Logo are registered trademarks of EIZO Corporation in Japan and other countries.
ColorNavigator is a trademark of EIZO Corporation.
All other company and product names are trademarks or registered trademarks of their respective owners.

1

Installing the software

This sensor is for the calibration of monitors in the ColorEdge series using color management
software “ColorNavigator 7”. ColorNavigator 7 software needs to be installed to enable use of
EX4. For more information about how to install, see ColorNavigator 7 Installation Guide.

How to attach the EX4

Attention

• Before attaching the EX4, remove the stains or dusts on the surface of the monitor.

Connect the monitor and the PC with the USB cable supplied with

1.

your monitor.

For more information about how to connect, see the Setup Guide for the monitor.

Remove the cap (counterweight) from the sensor.

2.

Counterweight

Sensor

Connect the EX4 to the USB downstream port of either the PC or the

3.

monitor.

2

Suspend the sensor in its measuring position on the monitor by

4.

carefully adjusting the counterweight’s position until both are in
balance.

Counterweight

Counterweight

Slide Slowly

English

3

Specications

79.1

Interface USB
Enviromental Specications Temperature Operation: 15 °C – 35 °C

Storage: -10 °C – 60 °C

Humidity Operation: 30 % – 80 % R.H.Non-condensing

Storage: 30 % – 80 % R.H.Non-condensing

Power Supply 5.0 ± 2.5 V max.100 mA

Mass Approx.148 g
Dimensions 79.1 mm (W) × 75.5 mm (H) × 45.7 mm (D)

Certications and Standards CE, FCC-A

Attention

• Take care that the sensor does not su󰀨er impact by dropping or other means, or it may a󰀨ect the
accuracy of the measurement. Storing or using the sensor at a temperature of under 30 °C and a
humidity of under 70% is recommended (avoid storing or using the sensor where it may be exposed
to direct sunlight).

Dimensions

⿟

Unit: mm

4

75.51620

45.7