EK100BM
LOW PROFILE CONDENSER
BOUNDARY MICROPHONE
USER’S MANUAL
ENGLISH
General
Low profile condenser phantom powered boundary microphone.
This elegantly shaped microphone has an extended and flat frequency
response.
It is available in black and can be used on a table or flat surfaces.
It features a mini -XLR output connector and it's supplied with an XLR
terminated cable.
Product complies with CE regulations
Precautions
• Before installing this unit please read carefully these
instructions, and keep this owner’s manual for future
reference.
• WARNING: improper installation could irreparably damage
the unit.
• Be careful that unit operation may not cause damage to
people.
• Place the unit in a location protected from weather and far
from water and moisture.
• Don’t place this unit close to heat sources (radiators,
spotlights, amplifiers etc.).
• Avoid any liquid entering inside the unit.
No user-serviceable parts inside.
Refer servicing to an authorized maintenance centre only.
Installation
1. Being careful about mounting direction, insert the mini XLR
connector on the rear EK100BM microphone.
2. Connect microphone base to an external unit (mixer,
amplifier, etc.) using supplied cable. If the external unit
microphone input can supply Phantom power, apply it to
this microphone by switching Phantom power on
Note: before connecting the microphone to the external unit, it must be
turned off and with its volume settings at minimum.
Loading...