EIKI WX5000, WX5000L User Guide
Setup and Projection
This Quick Guide shows the basic operation (projector connecting with the
computer using an RGB cable). Before using the projector, please read the
Owner’s Manual carefully.
1.
Place the projector facing a screen
2.
Connect the projector to the computer and plug the power cord
into the AC socket of the projector
3.
Remove the lens cap and turn the projector on
EIP-WX5000/WX5000L
Quick Guide
4.
Adjust the angle
5.
Adjust the focus and the zoom
8.
Turn the power off
7.
Select the input mode
1
Press H&V LENS SHIFT on the projector or on the remote control.
1
Press FOCUS +/– on the projector or on the remote control to adjust the focus.
2
Press ZOOM +/– on the projector or on the remote control to adjust the zoom.
2
Press ', ", \ or | on the projector or the remote control.
Adjust the projector angle:
Adjust the projector angle by rotating the adjustment feet.
Press INPUT on the projector or COMPUTER1 on the remote control to select the “COMPUTER1” mode.
•
•
You can unplug the power cord even if the projector is operating.
Even if you unplug the power cord from the AC outlet, the cooling fan continues to run for a while.
6.
Correcting the image distortion due to the projection angle
1
Press KEYSTONE on the projector or on the
remote control.
2
Press ENTER on the projector or on the
remote control.
3
Press ', ", \ or | to move the position for
the upper left of the image.
4
Press ENTER to set the position.
5
Repeat the same procedure with the positions
for the upper right, lower right and lower left of
the image.
5
4
6
7
6
7
6
4
3
8
Shift the lens horizontally and vertically.
On the remote
control
On the
projector
INPUT list On-screen Display (RGB)
Press STANDBY-ON on the projector or on the remote control. While the confirmation message is
displayed, press STANDBY-ON again.
""
""
"
On-screen Display
4
6
7
4
3 8
5
6
•
•
When the position of the lower left is set, the
correction is made and the display disappears.
•
When you press INPUT on the projector, the INPUT list appears.
Press '/" to switch the INPUT mode and then press ENTER.
When using the remote control, press COMPUTER1/2, DVI, HDMI, VIDEO or S-VIDEO to switch the
input mode.
•
•
®
Press STANDBY-ON on the projector or on the remote
control.
Switching the Input Mode:
Printed in China
XXXXXXXXXXXXX
08P07-CH-NM
Loading...