Eiki AH-69601 User Manual

MODEL AH-69601

Smoke Resistant Box

OWNER’S MANUAL

Before operating this Projector, read this manual thoroughly and operate the projector properly.

Provide appropriate space on the top, sides and rear of the Projector and Smoke Resistant Box for allowing
air circulation and cooling the Projector. Minimum clearance must be maintained. If the Projector is to be
built into a compartment or similarly enclosed, the minimum distances must be maintained. Do not cover the
ventilation slot on the Projector and Smoke Resistant Box. Heat buildup can reduce the service life of your
projector and Smoke Resistant Box, and can also be dangerous.

READ AND KEEP THIS OWNER'S MANUAL FOR LATER USE.

2

TO THE OWNER

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION :

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO
USER-SERVICEABLE PARTS INSIDE EXCEPT FILTER REPLACEMENT. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.

THIS SYMBOL INDICATES THAT DANGER­OUS VOLTAGE CONSTITUTING A RISK OF
ELECTRIC SHOCK IS PRESENT WITHIN
THIS UNIT.

WARNING :

TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE.

THIS SYMBOL INDICATES THAT THERE
ARE IMPORTANT OPERATING AND MAIN­TENANCE INSTRUCTIONS IN THE OWN­ER'S MANUAL WITH THIS UNIT.

Federal Communication Commission Notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Do not make any changes or modifications to the equipment unless otherwise specified in the instructions. If such
changes or modifications should be made, you could be required to stop operation of the equipment.

CAUTION

This is a Class A equipment. This equipment can cause interference in residential areas; in this case, the operator
can be asked to take adequate countermeasures.

The CE Mark is a Directive conformity mark of the European Community (EC).

• The Smoke Resistant Box protects the projector
from dust and cigarette smoke by adopting a highly
efficient filter.

• Provide two powerful silent rotary fans, and cool
down the Projector efficiently.

• It has been designed for easy mounting.

3

FEATURES

FEATURES ················································································································ 3

PART NAMES ············································································································ 4

INSTALLATION ········································································································· 5

OPERATION ·············································································································· 7

FILTER REPLACEMENT···································································································· 8

FILTER TIME CHECK AND RESET··················································································· 10

APPENDIX·················································································································11

MAINTENANCE ················································································································· 11

TROUBLESHOOTING········································································································ 11

DIMENSIONS····················································································································· 12

SPECIFICATIONS ·············································································································· 12

TABLE OF CONTENTS

FEATURES

4

PART NAMES

MOUNTING SCREWS
(provided on each corner)
(Screws are provided in the holes)

FILTER COVER
(AIR INTAKE VENTS)

PART NAMES

FILTER

FRONT

INDICATORS

REAR

CONNECTOR

Please ensure that there is sufficient clearance around the unit at the time of installation, as shown in the
figure on the right.

Take out the Smoke Resistant Box from the
packaging and place it on a flat surface with the
projector.

Take off the connector cover from the Projector.

5

INSTALLATION

PRECAUTION BEFORE INSTALLATION

PROCEDURE OF INSTALLATION

1

2

CONNECTOR COVER

INSTALLATION

PRECAUTION BEFORE INSTALLATION

PRECAUTION BEFORE INSTALLATION

WARNING: DO NOT COVER INTAKE
VENTS.

If the Air Intake is covered, there will be in­sufficient cooling which may result in failure
or fire.

At least 20'' (50cm)

At least

30''

(75cm)

At least

40''

(100cm)

AIR INTAKE VENTS

CAUTION:UNPLUG THE PROJECTOR FROM THE AC OUTLET WHEN INSTALLING THE
SMOKE RESISTANT BOX.
ATTACHING THE SMOKE RESISTANT BOX WHILE THE PROJECTOR IS CONNECTED TO
ELECTRICITY MAY DAMAGE THE BOX OR CAUSE IT TO MALFUNCTION.

PROCEDURE OF INSTALLATION

PROCEDURE OF INSTALLATION

FRONT

RETAIN THE CONNECTOR COVER.
WHEN THE SMOKE RESISTANT BOX IS NOT
BEING USED, REATTACH THE CONNECTOR
COVER TO THE PROJECTOR TO PROTECT
THE CONNECTOR.

Align the connector of the Projector with the
connector pins of the Smoke Resistant Box.

Hold the Smoke Resistant Box parallel to the
Projector and push it slowly towards the Projector.

Hold the Smoke Resistant Box with one hand and
use a Phillips-head screwdriver to tighten the four
fixed screws to fix the box in place.

Check that the Smoke Resistant Box is fixed in place with the four screws and no wide gap exists
between the projector body and the box.

6

INSTALLATION

3

4

5

6

PINS

PHILLIPS-HEAD
SCREWDRIVER

CAUTION:
THE CONNECTOR OR APPLY SHOCK
THAT MAY DAMAGE THE CONNECTOR.

TAKE CARE NOT TO TOUCH

THERE SHOULD BE NO WIDE GAP THERE SHOULD BE NO WIDE GAP

When the Projector is turned on, the POWER indicator lights in green.
* When the POWER indicator does not light and the WARNING FILTER indicator flashes, the filter is not

attached to the Smoke Resistant Box. In this case, the READY indicator on the Projector does not light
and the Projector can not be turned on.

INDICATORS OPERATION

WARNING FILTER . . . . Normally this does not light. Should the filter become clogged with dust particles

indicator flashes orenge. When the filter needs to be replaced, indicator lights in
orange. The filter should then be replaced immediately. When the filter is not
attached, the indicator will flash.

WARNING . . . . . . . . . . Normally this does not light. When the box's fan is operating abnormally, indicator

flashes red. When this occurs, turn off power immediately and request a
maintenance check. Do not leave the Smoke Resistant Box operational while the
indicator is flashing as it may become a fire and/or accident hazard.

When the Smoke Resistant Box is used for the first time, the initial set-up should be performed in the
following procedures. The Smoke Resistant Box cannot be operated or handled properly without this initial
set-up.

First, properly attach the Smoke Resistant Box to
the Projector.

Turn on the Projector and display some images.
Check that each indicator on the Smoke Resistant
Box lights normally.

Go to next page

7

OPERATION

1

2

INITIAL SET-UP BEFORE USE

OPERATION

ORANGE

REDGREEN

INDICATORS

INITIAL SET-UP BEFORE USE

INITIAL SET-UP BEFORE USE

OFFOFFON

Select [SPECIAL] in the Projector's menu. Then select [Filter].

Select [Option box] and then select [Reset] and then [ Yes].
A message [Please wait---] will appear.
When this message disappears initial set-up is complete. Close the menu.

When replacing the filter, replace with a specified filter. A replacement filter can be ordered through your
dealer. When ordering the filter, give the following information to the dealer.

• Replacement Filter type No. : AH-69641(POA-FIL-140)

• Smoke Resistant Box type No. : AH-69601

Press the PUSH button on the filter cover.

8

OPERATION

3

4

PUSH BUTTON

1

FILTER REPLACEMENT

CAUTION:WHEN REPLACING THE FILTER, TURN OFF THE PROJECTOR.

Open the filter cover and take out the used filter.

Install the new filter.

Check that the filter is not tilted or warped and then
close the filter cover. This will lock it into place.

Reset the filter time.
Refer to "FILTER TIME CHECK AND RESET"

9

OPERATION

2

3

4

5

FILTER COVER

USED FILTER

CAUTION:
FILTERS RECOMMENDED BY THE
MANUFACTURER. THE USE OF OTHER
FILTERS MAY CAUSE THE BOX TO
MALFUNCTION OR ACCIDENT MAY
RESULT.
CAUTION:TAKE CARE NOT TO DAMA­GE THE FILTER DETECTION SWITCH
LOCATED INSIDE THE BOX WHEN IN­SERTING THE FILTER.

USE ONLY REPLACEMENT

FILTER DETECTION
SWITCH

NEW FILTER

The filter operation time can be checked in the
projector menu.

Open [INFORMATION] in the menu and check
[Option filter time] for the hour counter.

"Option filter time" menu will not exist when Smoke
Resistant Box is not attached on the projector.

Reset the filter time according to the following procedures:(Only reset the filter time when changing the filter.
The Smoke Resistant Box cannot be operated properly if it is reset other than filter change.)

Check that the Smoke Resistant Box is properly
attached to the projector.

Turn on the projector and display the screen.
Check all indicators on the Smoke Resistant Box
light normally.

Select [SPECIAL] in the projector's menu. Then
select [Filter].

Select [Option box] and then select [Reset] and then
[Yes].

A message [Please wait--] will appear. When it disappears Filter Time reset is completed. Close the
menu.

10

OPERATION

1

2

3

4

5

FILTER TIME CHECK

RESETTING THE FILTER TIME

OFFOFFON

•

•

※

FILTER TIME CHECK AND RESET

FILTER TIME CHECK

FILTER TIME CHECK

RESETTING THE FILTER TIME

RESETTING THE FILTER TIME

IF THE SMOKE RESISTANT BOX IS NOT USED LONG PERIOD OF THE TIME.

Remove the Smoke Resistant Box from the Projector and store in safe place.

CARE AND CLEANING OF THE CABINET.

Remove stains on the cabinet with a soft cloth. If the stain is particularly stubborn, use a cloth soaked in
a heavily diluted mild detergent, and finish with a dry cloth.

CARE FOR THE CABINET.

Do not apply volatile solvents such as insecticide to the cabinet or bring the casing into contact with
rubber, adhesive tape or vinyl products for a long time. This may result in degradation and paint
scratches.

DO NOT USE BENZENE OR THINNER.

If benzene or thinner is used, cabinet may be damaged. When using a chemical cloth, please follow the
instructions carefully.

CLEANING AIR INTAKE VENTS.

When using under dusty or smoky conditions, the performance may be impaired.
Remove dust frequently using a vacuum cleaner, etc.

11

APPENDIX

MAINTENANCE

•

•

•

•

•

PROBLEM

TRY THESE SOLUTIONS

TROUBLESHOOTING

PROBLEM

PROBLEM TRY THESE SOLUTIONS

NO POWER. Check that the Projector is connected to a power source.

WARNING FILTER
INDICATOR ILLUMI­NATES ORANGE.

•

•

Check that the POWER indicator is illuminated green.

•

When the WARNING indicator flashes red, the built-in rotary fan has malfunctioned and
halted operation. Please consult with your dealer agent.

•

Check if the orange WARNING FILTER indicator is flashing. The filter may have come loose.

When the WARNING FILTER indicator flashes or lights in orange, the filter should be

•

replaced with a new filter immediately.

TRY THESE SOLUTIONS

SMOKE RESISTANT BOX

ACCESSORIE

APPENDIX

ITEM

CONTENTS

NAME

QUANTITY

CONTENTS

12

DIMENSIONS

18.1''

(461mm)

6.5''

(165mm)

TOP

8.5''

(216mm)

FRONT

SPECIFICATIONS

ITEM

ITEM CONTENTS

TYPE Projector smoke proof and dustproof box

AIR CAPACITY Approximately 2.0m /min

INDICATORS POWER, WARNING FILTER, WARNING

OPERATING CONDITIONS 41 to 95 (5 to 35 ) (indoors)

DIMENSIONS 6.5''x8.5"x18.1" (165mm x 216mm x 461mm)

NET WEIGHT Approximately 7.5lbs (3.4Kg)

3

NAME

NAME QUANTITY CONTENTS

Owner's Manual Smoke Resistant Box1

QUANTITY

CONTENTS

RIGHT SIDE

CONTENTS

Printed in Japan

© 2004 Eiki International, Inc.

A-key to better communications

U.S.A.

EIKI International, Inc.
30251 Esperanza
Rancho Santa Margarita
CA 92688-2132
U.S.A.
Tel : [phone] (949)-457-0200
Fax : [phone] (949)-457-7878
E-Mail : [e-mail]

Canada

Deutschland & Österreich

EIKI Deutschland GmbH
Am Frauwald 12
65510 Idstein
Deutschland
Tel : [phone]
Fax : [phone]
E-Mail : [e-mail]

Eastern Europe

EIKI CZECH spol. s.r.o.
Umelecká 15
170 00 Praha 7
Czech Republic
Tel : [phone]

[phone]
Fax : [phone]
E-Mail : [e-mail]

Japan & Worldwide

EIKI Industrial Company Limited.
4-12 Banzai-Cho, Kita-Ku, Osaka,
530-0028 Japan
Tel : [phone]
Fax : [phone]
E-Mail : [e-mail]

WorldWide Website http://www.eiki.com

ˆ

EIKI CANADA - Eiki International, Inc.
P.O. Box 156, 310 First St. - Unit 2,
Midland, ON, L4R 4K8, Canada
Tel : [phone] (705)-527-4084
Fax : [phone] (705)-527-4087
E-Mail : [e-mail]