Eiki AH-38321, AH-38323 Owner's Manual
Smoke Resistant Unit
Model AH-38321
Smoke Resistant Filter
Model AH-38323
OWNER'S MANUAL
To the owner:
This Smoke Resistant Unit is designed for a specified projector under smoky or dusty
conditions. When installing or replacing it, refer to this manual.
Unpack and check that you have all of the items below (except for this manual). If
any of these items is missing, please contact your place of purchase.
Smoke Resistant Unit x1 Smoke Resistant Filter x1
Printed in Japan 1AA6P1P5973-- (IJAJ-EK)
AH-38321 AH-38323
2
Using the Optional Smoke Resistant Unit
1
Press the ON/STAND-BY button on the
side control or the STAND-BY button on
the remote control, flip the Main On/Off
Switch off, and then unplug the AC power
cord from the AC outlet.
2
Loosen the 2 screws that secure the AMC
unit and pull it out.
3
Insert the Smoke Resistant Unit into the
projector completely and fix it with the 2
screws.
4
Plug the power cord, power on the
projector and reset the filter counter.
AMC Unit
Screws
Setting the Filter Counter Timer for Smoke Resistant Unit
Filter counter
Use the Point ed buttons to select Filter counter and then press the Point 8 or the
SELECT button to access the submenu items.
Filter counter ........ Shows the total used filter time. The Filter counter is displayed in
red when exceeding the
setup time in the Filter
counter timer, or filter
clogging was detected.
Filter counter remaining
. Shows the remaining
value every 10%.
- When the remaining
value reaches 10%...
- It is displayed in red.
- This icon ( ) appears.
- When the remaining
value reaches 0%, the
WARNING FILTER
indicator lights up.
Filter counter timer
. Sets the timing to
replace with a new filter. The filter replacement icon appears
when Filter counter exceeds the setup time or filter clogging is
detected. (Off/10H/15H/20H)
- When the time reaches the setup timer, the WARNING FILTER indicator
lights up.
Press the SELECT button to select Filter
counter timer and use the Point ed buttons
to set the timer. Select from (Off/ 10H/ 15H/
20) depending on the use environment.
Filter Counter Menu
- Tighten the screws securely. If the
screws are not tighten securely, the
Smoke Resistant Unit is possibility
falling.
- When the unit is not installed
properly, the projector failed to light.
- When using this Smoke Resistant Unit, we recommend to set the “Display” function to “On”.
(p.54 : Owner's Manual). If the "Display" function cannot be set to "On", We recommend to
periodically check the "Filter counter" menu for monitoring the filter condition.
Loading...