EIC FWL08G, FWL06G, FWL04G, FWL02G, FWL01G Datasheet
...
FWL005G - FWL10G
PASSIVATED BRIDGE RECTIFIERS
PRV : 50 - 1000 Volts
FEATURES :
MECHANICAL DATA :
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25
°
C ambient temperature unless otherwise specified.
Single phase, half wave, 60 Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
Notes :
1 ) Measured with I
F
= 0.5 Amp., I
R
= 1 Amp., Irr = 0.25 Amp.
2 ) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts.
UPDATE : APRIL 23,1998
FAST RECOVERY GLASS
Io : 1.0 Ampere
* Glass passivated chip
* High case dielectric strength
* High surge current capability
* High reliability
* Low reverse current
* Low forward voltage drop
* Ideal for printed circuit board
* Fast switching for high efficiency
* Case : Reliable low cost construction
utilizing molded plastic technique
* Epoxy : UL94V-O rate flame retardant
* Terminals : Plated leads solderable per
MIL-STD-202, Method 208 guaranteed
* Polarity : Polarity symbols marked on case
* Mounting position : Any
* Weight : 1.29 grams
WOB
0.39 (10.0)
0.31 (7.87)
0.22 (5.59)
0.18 (4.57)
MIN.
1.10 (27.9)
0.22 (5.59)
0.18 (4.57)
Dimension in inches and (millimeter)
AC
+
-
0.034 (0.86)
0.028 (0.71)
-AC
AC
1.00 (25.4)
MIN.
0.22 (5.59)
0.18 (4.57)
+
FWL
FWL
FWL
FWL
FWL
FWL
RATING
Maximum Recurrent Peak Reverse Voltage VRRM 50 100 200 400 600 800 1000 Volts
Maximum RMS Voltage VRMS 35 70 140 280 420 560 700 Volts
Maximum DC Blocking Voltage VDC 50 100 200 400 600 800 1000 Volts
Maximum Average Forward Current
0.375" (9.5 mm) lead length Tc = 50°C IF(AV) 1.0 Amps.
Peak Forward Surge Current Single half sine wave
Superimposed on rated load (JEDEC Method) IFSM 30 Amps.
Rating for fusing ( t < 8.3 ms. )
Maximum Forward Voltage per Diode at IF = 1.0 Amp. VF 1.3 Volts
Maximum DC Reverse Current Ta = 25 °C IR 10 µA
at Rated DC Blocking Voltage Ta = 100 °C IR(H) 1.0 mA
Maximum Reverse Recovery Time (Note 1) Trr 150 250 500 ns
Typical Junction Capacitance per Diode (Note 2) CJ 24 pf
Typical Thermal Resistance (Note 3) RθJA 36 °C/W
Operating Junction Temperature Range TJ - 50 to + 150 °C
Storage Temperature Range TSTG - 50 to + 150 °C
SYMBOL
I2t
005G
01G
02G
04G
10
06G
08G
FWL
10G
UNIT
A2S
3 ) Thermal resistance from Junction to Ambient at 0.375" (9.5 mm) lead length P.C. Board mounting.
RATING AND CHARACTERISTIC CURVES ( FWL005G - FWL10G )
FIG.1 - REVERSE RECOVERY TIME CHARACTERISTIC AND TEST CIRCUIT DIAGRAM
1.0
1.0
24030
0
1
0.01
0.1
18
+ 0.5 A0- 0.25
- 1.0 A
1 cm
50 Ω 10 Ω
D.U.T.
50 Vdc
(approx)
1 Ω
NOTES : 1. Rise Time = 7 ns max., Input Impedance = 1 megaohm, 22 pF.
2. Rise time = 10 ns max., Source Impedance = 50 ohms.
3. All Resistors = Non-inductive Types.
OSCILLOSCOPE
( NOTE 1 )
PULSE
GENERATOR
( NOTE 2 )
Trr
SET TIME BASE FOR 50/100 ns/cm
FIG.2 - DERATING CURVE FOR OUTPUT FIG.3 - MAXIMUM NON-REPETITIVE PEAK
RECTIFIED CURRENT FORWARD SURGE CURRENT
PC Board
0.8
0.6
0.4
CURRENT, AMPERES
0.2
AVERAGE FORWARD OUTPUT
60 Hz, Resistive or Inductive load.
0 25 50 75 100 125 150 175 1 2 4 6 10 20 40 60 100
CASE TEMPERATURE, ( °C)
0.375(9.5mm)
Copper Pads
0.22" x 0.22"
(5.5 x5.5mm)
12
CURRENT, AMPERES
6
PEAK FORWARD SURGE
SINGLE HALF SINE WAVE
(JEDEC METHOD)
NUMBER OF CYCLES AT 60Hz
TJ = 55 °C
FIG.4 - TYPICAL FORWARD CHARACTERISTICS FIG.5 - TYPICAL REVERSE CHARACTERISTICS
20
10
TJ = 25 °C
0.1
Pulse Width = 300 µs
1 % Duty Cycle
FORWARD CURRENT, AMPERES
0.01
0.4 0.8 1.2 1.6 2.0 2.4 2.8 3.2
FORWARD VOLTAGE, VOLTS
10
TJ = 100 °C
TJ = 25 °C
REVERSE CURRENT, MICROAMPERES
0 20 40 60
80
100 140
PERCENT OF RATED REVERSE
VOLTAGE, (%)
120
Loading...