EHRET PERSIENNE Installation Instructions Manual
PERSIENNE
Aluminium folding shutters
Installation instructions
INSTALLATION BY
SPECIALIST PERSONNEL
Valid from 06.2017
E 634.1
Notes
These installation instructions describe the installation and commissioning of PERSIENNE
folding shutters.
Carefully read through these instructions prior
to commissioning. Observe the specified process steps and take into account the notes and
recommendations given. Knowledge of and
technically impeccable implementation of the
given safety notes and warnings are prerequisites for safe and proper operation of the folding shutters. Insufficient knowledge at the time
of commissioning and utilisation lead to the
loss of any liability claims against EHRET
GmbH. Installation and/or operation in full or
partial deviation from our installation and operating instructions will lead to the warranty for
defects becoming void.
These installation instructions are a component
part of the product and are therefore always to
be retained until the product is disposed of.
These installation instructions are to be passed
along in the event of the sale of this product.
These instructions are addressed to qualified
specialist personnel. Qualified specialist personnel are persons who are familiar with the
transport, set-up, installation, commissioning
and operation of the product and who have appropriate qualifications for their work. Specialist
personnel must know and observe the relevant
standards and/or guidelines.
This product complies with the general rules of
technology. Safety-conscious behaviour is necessary for commissioning the product safely.
For this reason, observe the following notes.
Should any of the information in these installation instructions not be absolutely clear, it is essential that you contact the specialist personnel
at EHRET GmbH, 77972 Mahlberg (Germany).
Bore hole sizes and fastening material are recommendations only and may vary depending
on the substrate!
2
Contents
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Explanation of signs and symbols . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Safety notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
EC Declaration of Conformity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Installation FAQs . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
1 Product description
Scope of delivery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Tools required . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Operating principle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
2 Installation instrucions
Pre-drilling the hinge profile . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Fastening sash packet 1 to the connection profile . . . . . . . . . . . . . . . . . . . . . . 12
Fastening sash packet 2 to the connection profile (for double-sided diagrams) . . . . . . . 13
Mounting the shutter catch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Mounting the stop angle. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
3
Important notes
Explanation of signs and symbols
Warning notes
DANGER
Designates an imminent danger that
could lead to death or severe injuries if
the respective precautionary measures
are not implemented.
WARNING
Means that death, severe bodily injury or
major property damage could occur if the
respective precautionary measures are
not implemented.
CAUTION
Means a possible danger that could lead
to minor injuries or property damage if it
is not avoided.
Directives for action
Safety notes
Only qualified specialist personnel may
carry out installation and commissioning!
WARNING
Incorrect installation could lead to severe injuries and/or damage to property.
Follow all installation instructions.
WARNING
Take into account the following notes
and warnings in order to avoid dangers
and to protect the product.
Observe the accident prevention regulations
of the Accident Prevention & Insurance Association.
Observe the rules of the road during trans-
port.
Make sure that the load is well-secured on
the means of transport.
Cordon off a generously large area around
the installation site.
Observe without limitation the regulations
of the manufacturers of dowel and fitting
materials.
The mounting bases of the installation site
are to be checked for load-bearing capacity
prior to installation.
In the event of uncertainties about the
mounting bases, contact your responsible
building experts.
Check the product for damage prior to instal-
lation. Products requiring repair may not be
used.
4
Important notes
No personnel or obstacles are permitted to
be within the range of pivoting and/or travelling shutters while they are moving. Keep
personnel and objects away until the shutters have reached their final position.
Do not reach into moving parts or closing
areas while shutters are opening or closing.
Make sure that no articles of clothing or
body parts are able to be caught by moving
parts in the system.
Ice could form on the product in the event of
snowfall, sleet or icy rain. Do not operate
equipment until the ice formation is no longer present, and switch automatic controls to
manual.
Make sure that the shutters are locked be-
fore any wind load occurs.
The shutters may not be operated at wind
speeds from 62 km/h (stormy wind).
No additional loads such as persons or ob-
jects are permitted to have an effect on the
shutters.
Shutters are not intended to protect individ-
uals from falls.
WARNING
Danger of injury from the weight of
the product!
Due to the weight of the products,
transport and installation must be carried out by at least two individuals.
WARNING
Danger of suffocation from packaging
foil.
The packaging foil must be kept out of
reach of children.
Store the foil carefully until you turn it in
for recycling.
Turn the packaging materials in for recy-
cling.
Transport the product carefully in order to
avoid damage.
Take care to ensure that the product is not
damaged when the packaging material is removed.
5
Loading...